Hifiverse

Endstufen Stereo - Kora CSA 2120

Beschreibung, Bilder, technische Daten und Spezifikationen

Kora CSA 2120
Bildquelle - (c) Kora

The CSA 2120 is a pure Class A stereo power amplifier from Kora of Toulouse. Kora unveiled its CSA series at the Munich show in May 2025 in four versions, small or large, mono or stereo, and the CSA 2120 is the large stereo model. In France it is priced at EUR 28,200.

Key specs that matter

Output power is 2 x 120 W into 8 ohms in pure Class A. A linear power supply with 560,000 µF of filtering is used. Each channel has an unbalanced RCA input (47 kohms) and a balanced XLR input (20 kohms), plus its own GAIN potentiometer. Kora quotes 280 W consumption in normal operation and less than 15 W in standby. The aluminium and steel case in Mineral grey measures 420 x 660 x 260 mm and weighs 45 kg, and a power cord and manual are supplied.

Engineering and use context

Like the rest of the Kora range, the CSA 2120 is powered by Square Tube and combines tubes with audio transistors. Its output stage is pure Class A in the strict sense, with the signal taken from the collector and the transistors biased in the middle of their characteristics, so crossover distortion is pushed back to the point of clipping. In the large versions there are 60 output transistors. According to Kora, this power stage is insensitive to current feedback from the output filter or the speakers and stays stable on complex, highly capacitive loads. It is designed as a current source. A voltage/current converter made only of precision resistors, without semiconductors, links the Square Tube to the power section, and Kora also credits it with correct phase.

In Class A the two supply voltages are fixed, and the current through the transistors varies around the quiescent current. Power sent to the speakers is subtracted from the power dissipated at idle, so the amplifier cools down when it delivers a lot of power. Two current levels are available - nominal for full power and an economical mode at half the current. In AUTO it changes to high current when the signal requires it and returns to low current in about ten seconds. A slow pre-charge limits inrush current, although peaks of 10 to 20 A are still possible. Its display shows standby, heating, welcome, operating and goodbye screens, and in operation a table of values for each channel, which may differ slightly between the two sides.

Pairing

A preamplifier is required, and the matching Kora preamplifier is the PR140. The separate GAIN controls allow correction of small sensitivity differences between two speakers. Kora specifies flexible multi-strand speaker cable of large cross-section, since pulses can exceed ten amps.

Alternatives

The Kora CSA 270 is the small stereo model of the same series, rated at 2 x 70 W into 8 ohms and priced at EUR 19,800 in France.

Spezifikationen

  • Modellbezeichnung

    CSA 2120

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    2 x 120

  • Ausgangsleistung (4Ω) (W)

    N/A

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    N/A

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    420 x 660 x 260

  • Gewicht (kg)

    45

  • Offizieller Link

Weitere Komponenten