Hifiverse

Endstufen Stereo - Line Magnetic Audio AS-125N

Beschreibung, Bilder, technische Daten und Spezifikationen

Line Magnetic Audio AS-125N
Bildquelle - (c) Line Magnetic Audio

The AS-125N is a single-ended triode integrated amplifier from Line Magnetic, sold under its Analog Sound label. On the LM Audio Foshan site it is listed in the Analog Series as the AS-125 Integrated Amplifier (211 Single Ended). It has a full preamplifier stage and input switching and can also run as a power amplifier. An export-only variant, the AS-325N, uses upgraded components on the same basis. Line Magnetic's founder, the late Zheng Cai, set out to recreate classic Western Electric transformers and circuits.

Key specs that matter

Output is 18 W RMS per channel in class A single-ended operation. Its tube complement is three 12AX7, two 6SN7 and two directly heated 211 output tubes. Input impedance is 100 kohms / 600 ohms, sensitivity is 500 mV and gain is selectable at 40 or 52 dB. Frequency response is 10 Hz - 45 kHz (±2 dB), signal-to-noise ratio is 88 dB and THD is 1%. Four pairs of RCA inputs are provided, and output taps cover 4, 8 and 16 ohm loudspeakers. The grey chassis measures 480 x 275 x 490 mm (W x H x D). Line Magnetic gives the weight as 110 lb (about 50 kg), or about 70 kg crated.

Engineering and use context

Three amplification stages are wired by hand, point to point. At the input sits a Line Magnetic copy of the Western Electric 618 transformer, ahead of a full preamplifier stage rather than a plain volume control. Its output transformers also follow Western Electric practice. A front-panel switch changes the unit between integrated and power amplifier modes.

Two power transformers are used, one for the high-voltage supply and one for the low-voltage supply, each with its own mains inlet. Bias for the 211 tubes is automatic, and Line Magnetic recommends matched tubes. The front-panel meter can be switched off, and a remote control is included.

Pairing

High-efficiency loudspeakers are required. The output taps allow matching to the rated impedance of the speaker. In power amplifier mode the matching line stage is the Analog Sound AS-133 tube preamplifier.

Alternatives

The Line Magnetic LM-845IA is a single-ended integrated amplifier with 845 output tubes, rated at 2 x 22 W.

Spezifikationen

  • Modellbezeichnung

    AS-125N

  • Eingangsempfindlichkeit (mV)

    N/A

  • Eingangsimpedanz (symmetrisch) (Ω)

    N/A

  • Eingangsimpedanz (unsymmetrisch) (Ω)

    100 000

  • Ausgangsimpedanz (symmetrisch) (Ω)

    N/A

  • Ausgangsimpedanz (unsymmetrisch) (Ω)

    N/A

  • Maximaler Strom (A)

    N/A

  • Ausgangsleistung (8Ω) (W)

    2 x 18

  • Ausgangsleistung (4Ω) (W)

    N/A

  • Verstärkung (dBu)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Signal-Rausch-Abstand (dB)

    N/A

  • Klirrfaktor + Rauschen (0% Gegenkopplung) (%)

    N/A

  • Klirrfaktor + Rauschen (100% Gegenkopplung) (%)

    N/A

  • Maximale Leistungsaufnahme (W)

    N/A

  • Dämpfungsfaktor

    N/A

  • Abmessungen (mm)

    480 x 490 x 275

  • Gewicht (kg)

    52

  • Offizieller Link