The M500 is the mono block power amplifier of FLUO, based in Winchester, England. Each M500 is housed in its own chassis, so a stereo system needs two units. Its FLUO circuit concept has two stated objectives - an output that stays correct at any level and frequency, and an output that is a constant linear factor of the input.
Key specs that matter
One M500 is rated at 500 W into 8 ohms and 1,000 W into 4 ohms (resistive load). Into 2 ohms it reaches 2,000 W short-term, reduced to about 1,800 W by the mains fusing. Two 6.3 A slow-blow mains fuses limit long-term consumption to 2,900 W. Idle consumption is 100 W per mono block, with all data based on 230 V AC mains. Inputs are a balanced 3-pin XLR at 40 kOhm (pin 2 plus) and an unbalanced RCA at 20 kOhm. Each chassis measures 485 x 270 x 535 mm (W x H x D).
Engineering and use context
Every M500 has its own dedicated mains transformer, so the demand of one loudspeaker does not affect the supply of the other. Its output stage uses one Single Die MOSFET instead of several paralleled transistors, giving one current path to the loudspeaker. FLUO rates this device at 388 A peak current and around 450 W, while a 2 ohm load requires 38 A. Resistance through the MOSFET is 0.022 ohm. According to FLUO, resistance is also lowered in the mains transformer, the PCB layout, the capacitors and the internal wiring. The quoted working range is 16 Hz to beyond 20 kHz.
A protection circuit monitors high frequencies, voltage, current, phase angle and load, mutes the input for 1 second on a fault and restarts automatically once the fault is cleared. Loads below 1.5 ohms are refused, and the audio mutes if operating temperatures exceed the limit.
The single-MOSFET concept goes back to Danish engineer Ole Lund Christensen. In 1982 he began with an industrial N-channel MOSFET of 70 W, which led to the SLT 250, rated at 2 x 250 W into 8 ohms and 1,000 W bridged. In 1995 he completed the SiriuS DM 200, a single-MOSFET power amplifier of 200 W into 8 ohms, which became the foundation of the GamuT brand five years later.
Pairing
The matching preamplifier is the FLUO PRE1, a dual mono design on two independent PCBs with the same JFET balanced input circuit and 20 kOhm on both XLR pins. FLUO recommends shielded signal cables only.
Alternatives
FLUO has no other mono block power amplifier, as its DM125 and DM250 carry two channels in one chassis.