The Allnic Audio T-2000 30th is the anniversary edition of the T-2000 tube integrated amplifier, issued to mark thirty years of the company. Its main change over the earlier KT150 version is a new output tube, the KT170, which lifts the rated power from 100 W to 120 W in pentode mode and from 50 W to 60 W in triode mode. The list price was USD 13,900 in the United States and EUR 16,200 in Europe, with a black or silver chassis.
Key specs that matter
The output stage works in push-pull, and power is 120 W into 8 ohm at 1 kHz in pentode mode, and distortion plus noise is 0.17 percent at 1 kHz and 10 W. Allnic quotes a flat response from 20 Hz to 20 kHz, 80 dB of signal-to-noise (CCIR, 1 kHz) and a damping factor of 8 into an 8 ohm load. Input sensitivity for rated power is 1.3 V, and the input impedance is 100 kohm. Sources connect through three unbalanced RCA sockets and a pair of balanced XLR sockets. Overall dimensions are 440 x 480 x 300 mm, and the net weight is 36 kg.
Engineering and use context
The amplifier holds two 6J4 tubes in the first stage, four D3a tubes as second-stage drivers and four Tung-Sol KT170 output tubes. The D3a drivers run in triode connection with a 9 kohm load and 12 mA of current. A front-panel switch moves the KT170s from pentode to triode operation and back, even while music is playing. Allnic winds its own transformers, and their cores use Permalloy, an iron-nickel alloy. In what Allnic calls Full Engagement, each output transformer has four separate secondaries, all of them wired to the speaker terminals permanently, while a rear selector chooses between the 4 ohm and 8 ohm settings. The level control is a 61-step attenuator with silver contacts, built by Allnic itself and adjustable from the remote, used in place of a carbon potentiometer for constant impedance and close channel balance. An analogue meter on each channel shows the bias of the output tubes, a small switch picks which tube is read, and trimmers set the quiescent current. A soft-start circuit holds back the high voltage for about 30 seconds until the tubes have warmed up.
Pairing
In pentode mode the T-2000 30th can run conventional floorstanding speakers of moderate sensitivity, while triode mode suits efficient designs that need less drive. Balanced sources, for example a streamer or phono preamplifier with XLR outputs, can be wired in without adapters. Given the low damping factor, loudspeakers whose impedance stays fairly flat across the band are the safer match.
Alternatives
Within the Allnic range, the T-1500 mk2 integrated amplifier is the lower-powered choice and uses two 300B triodes in single-ended class A.