The Allnic Audio T-1800 MK2 is an integrated stereo tube amplifier made by the Korean company Allnic Audio, and its push-pull output stage runs two EL34 power tubes per channel. British pricing was GBP 8,000 including VAT, with silver and black versions offered.
Key specs that matter
Rated output is 40 W per channel into either 4 or 8 ohm at 1 kHz, with 0.1 percent distortion at 1 kHz and 2.83 V. Frequency response is flat from 20 Hz to 20 kHz, signal-to-noise reaches 80 dB (CCIR, 1 kHz) and the damping factor is 8 into an 8 ohm load at 1 kHz. Voltage gain is 38 dB, input sensitivity for rated power is 400 mV, with 10 kOhm presented at each single-ended input. The chassis measures 430 mm wide, 330 mm deep and 210 mm high, and it weighs 20 kg net.
Engineering and use context
Seven tubes are fitted in all. A 12AY7 forms the first driver stage, with a 6072 allowed as a substitute, and two E180CC tubes, a type close to the 5965 and 7062, form the second, so only two stages drive the four EL34s. The output tubes use a self-biased control grid. The output transformers have 96 mm cores of nickel and FeSi, a permalloy blend, and Allnic winds them as Full Engagement transformers whose four separate secondaries remain connected whichever tap is used. Speaker taps are 4 and 8 ohm, or 8 and 16 ohm when ordered that way from the factory. Level is set by a 41-step attenuator with silver contacts, made in-house in place of a carbon film potentiometer and operated from the remote. An analogue meter shows the current of the output tubes, and a needle falling below the marked zone tells the owner which EL34 has failed and needs replacing. A soft start holds back plate voltage for 30 to 40 seconds after the power switch on the right side panel is pressed. The manual asks for a solid stand and free air around, above and below the chassis.
Pairing
With output taps for low and high impedance loads, the amplifier can be matched to the nominal rating of most passive speakers, but a damping factor typical of tube designs favours speakers with an even impedance curve over ones with steep dips. Moderate to high sensitivity speakers make the best use of the available power. The input sensitivity suits common line-level components, whether a disc player, a streamer with analogue outputs or a separate tube phono stage.
Alternatives
The Allnic T-1500 MK2 is the single-ended 300B integrated amplifier of the same range.