The I-280 is the middle model of Aavik's I-180, I-280 and I-580 integrated amplifiers, all made in Denmark by Audio Group Denmark, the Aalborg company that also owns Ansuz and Børresen. All three have the same specified power output, inputs and enclosure dimensions and differ in the number of Ansuz noise-reduction circuits on board, with the copper inner chassis reserved for the I-580. Compared with the I-180, the I-280 doubles the count of active Tesla coils.
Key specs that matter
Rated output is 2 x 300 W into 8 ohms and 2 x 600 W into 4 ohms, with THD+N below 0.006% (1-100 W, 1 kHz, 8 ohms). IMD is below 0.002% and TIM below 0.008%, both measured at 1-100 W into 4 ohms. Five single-ended RCA line inputs present 10 kohms. Inputs 1-4 have 5-15 dB of adjustable gain and accept up to 4.5 V RMS, input 5 has 1-11 dB and accepts 6.5 V RMS, and the default gain is 9 dB, to which the power amplifier section adds 26 dB. A single RCA pre out delivers up to 7.5 V RMS with a 50 ohm output impedance. Line-stage THD is below 0.005% (1 kHz, 1 V input). The volume control has 76 steps of 1 dB. Ansuz noise reduction consists of 72 active Tesla coils, 168 active square Tesla coils, 8 dither circuits and 4 anti aerial resonance coils. Idle consumption is below 50 W. The case measures 400 x 384 x 102 mm (L x W x H) and weighs 9.0 kg.
Engineering and use context
Aavik's patented UMAC technology is a switching amplifier design in which the PWM signal comes from sine wave modulation, not the usual triangle modulation. According to Aavik, sine waves produce less high-frequency noise and need less inductive filtering at the output, and dual mixed mode feedback raises the damping factor. Volume is set in a line stage with an inverted, virtual ground topology whose feedback allows gain below unity.
Power comes from a resonant mode supply driven mainly by sine waves, and its operating frequency increases with demand. Ultra-low noise regulators follow, each supplying its own part of the circuit. In the analog dither circuits, active Tesla coils send pulsed signals at defined frequencies in counter phase. Anti aerial resonance coils are wound on the outside of cables against airborne RF noise. Aluminium in the enclosure is limited to what cooling requires, and the rest is a natural-based composite material.
Pairing
Spade connectors and 4 mm banana plugs fit the speaker terminals. A headphone amplifier on the pre out can stay active while the speaker outputs are muted. Two 12 V DC trigger outputs supply up to 80 mA in total.
Alternatives
The Aavik I-580 is the model above it in the trio, with the copper inner chassis, 108 active Tesla coils and a weight of 10.7 kg.