The Scorpio III is a stereo tube integrated amplifier from Ayon Audio of Gratkorn, Austria, and the third generation of a line that grew out of the Orion, the entry model Ayon introduced in 2008. It is a development of the Scorpio II. Ayon reinforced the mains transformer and power supply and installed new output transformers, while the appearance and basic architecture were retained. In the Netherlands it sold for EUR 4,400.
Key specs that matter
Four output tubes operate in class A, and the owner chooses KT150, KT88 or EL34. In pentode mode Ayon rates the output at 2 x 55 W with KT150, 2 x 43 W with KT88 and 2 x 38 W with EL34. Triode mode gives 2 x 35 W, 2 x 30 W and 2 x 25 W respectively. Bandwidth is 15 Hz - 40 kHz, input sensitivity is 350 mV for full power and input impedance is 100 kohms at 1 kHz. Negative feedback is 0 dB. Four line inputs are standard, and an optional USB DAC accepts PCM up to 32-bit/384 kHz and DSD256. Its chassis measures 460 x 360 x 260 mm (W x D x H) and weighs 29 kg.
Engineering and use context
There are no solid-state devices, followers or buffers in the signal path. Bias is adjusted automatically or manually and is read on an analogue bias meter on the chassis. Logical soft-start sequencing protects the tubes, the power-on cycle completes in 1 minute, and a power tube and electronic protection circuit is included.
Inside, the power transformers are low-noise, insulated, encased, damped and RFI/EMI shielded. The supply is choke filtered, each amplification stage has its own isolated supply, and the pre and driver tubes have a high-current filament regulator. Filaments run on regulated DC with soft start, an AC power line filter is installed and in-rush current is limited. Each output transformer uses multiple tightly coupled winding layers and is sealed with an anti-resonance compound.
Input selection uses relays located next to the RCA jacks. Ayon makes its own tube sockets with beryllium-copper spring pins, the internal signal cable is a copper matrix and the circuit boards are gold-plated industrial-grade PCBs. Hand assembled, the brushed, anodised and non-magnetic aluminium chassis sits on resonance-absorbing aluminium feet, carries machined control knobs and is finished in black or chrome. A metal remote control covers volume and mute.
Pairing
Output taps for 4 and 8 ohm loudspeakers are provided, and Ayon lists the amplifier for more difficult loudspeaker loads. Sources connect at line level only unless the USB DAC board is installed.
Alternatives
The Spirit V is another tube integrated amplifier in Ayon's current range.