The TT Hub is a belt-drive turntable from Connected-Fidelity, the British manufacturing arm of Air Audio Distribution, which imports Hana cartridges and Sorane tonearms into the UK. Designed by Michael Osborn, it was launched at the Bristol HiFi Show 2023 and sells in the USA for USD 5,000. It is supplied without tonearm and cartridge, and in the UK it is also offered with Sorane tonearm and Hana cartridge options.
Key specs that matter
Drive is by a precision flat belt from an AC synchronous motor pod with a remote speed controller. Speeds are 33.33 and 45 rpm with fine speed adjustment, and motor speed accuracy is 0.003%. The bearing is large in diameter and deep, with sintered bronze bearings and a sapphire thrust bearing between PEEK surfaces. Chassis parts and base-board are multi-layer bamboo plywood. The platter is acrylic with an attached foamed platter mat. One or two arm boards are standard, and three are available by special order. Dimensions are 85 x 540 x 162 mm (H x W x D), and weight is 14.5 kg.
Engineering and use context
TT Hub is a non-sprung design. It rests on compliant silicone feet under the base-board, and tuned composite spike shoes sit in its top face. Above them, the turntable body with adjustable brass spike feet is built from layers of bamboo plywood in a constrained-layer construction and carries the tonearm and bearing assembly. Connected-Fidelity describes bamboo plywood as very strong with little energy storing potential.
Its self-lubricating main bearing uses a PEEK base component and is housed in a thick-wall aluminium body. The platter sits on the drive pulley, which is connected to the bearing shaft. A semi-rigid foamed mat is bonded to the top face of the black acrylic platter.
A quartz clock controlled circuit runs the AC motor. Connected-Fidelity notes that mains frequency can vary by up to 2% from moment to moment. The controller runs the motor up to full speed and then reduces power slightly to reduce motor cogging. An isolation pod on the base-board houses the motor. Both the motor pod and the adjustable aluminium tonearm board have a matt silver anodised finish. Pre-cut boards exist for Sorane, Rega and Linn tonearms plus SME slider plates, and blank boards suit 9, 10 and 12 inch arms. Natural and dark stain finishes are offered.
Pairing
A tonearm, a cartridge and a phono stage are required. In the UK the matching options are a Sorane tonearm and a Hana cartridge.
Alternatives
Connected-Fidelity lists no other turntable model.