Hifiverse

Tonarme - Reed REED 3P 10.5"

Beschreibung, Bilder, technische Daten und Spezifikationen

Reed REED 3P 10.5"
Bildquelle - (c) Reed

Reed 3P is a tonearm from Reed of Lithuania with a wooden armwand and a three-pivot bearing. It is offered in three effective lengths, and this is the middle one, with a pivot to spindle distance of 251.6 mm. Prices start at USD 7,545. Each arm is assembled by hand to order, which takes four to six weeks, and a two-year warranty applies.

Key specs that matter

Pivot to spindle distance is 251.6 mm, and mounting distance is 236.1 mm. Overhang is 15.4 mm, with an offset angle of 20.7 degrees. Effective mass depends on the armwand wood - approximately 10 g in light or dark teak, 12 g in wenge and 14 g in Makassar ebony or cocobolo. VTA has a fine adjuster, and VTA, azimuth and anti-skating are all adjustable while a record is playing. Anti-skating is magnetic. Metal parts are offered in matte gold, glossy gold, black, seashell white and palladium.

Engineering and use context

Reed describes the bearing system as a gimbal type that acts like a unipivot. Instead of a single pivot, it uses three pivots, with magnetic stabilisers on both the vertical and the horizontal axis. According to Reed, this bearing is as rigid as a gimbal, while its friction coefficient is as low as that of a unipivot.

On the azimuth adjuster, the cartridge swings around the stylus tip during adjustment. All other tonearm parameters therefore stay unchanged when azimuth is set. Magnetic anti-skating and several other 3P features were developed in the Reed Mag prototype, first shown at Analog Forum 2011 in Krefeld, Germany.

Two other lengths complete the 3P range. At 223 mm pivot to spindle the mounting distance is 205.5 mm, with 17 mm overhang and 22.9 degrees offset, and at 295.6 mm it is 283.8 mm, with 13.4 mm overhang and 17.6 degrees offset. On the longest version the same wood gives 2 - 4 g more effective mass. The headshell is replaceable, and signal wiring from van den Hul or Zavfino is chosen at the time of ordering.

Pairing

An armboard drilled for the 236.1 mm mounting distance is required. Cable and plug type follow the input connectors of the phono stage.

Alternatives

The Reed 2B is a tonearm in the same three lengths, with low-friction ceramic bearings for cartridges up to 35 g.

Spezifikationen

  • Modellbezeichnung

    REED 3P 10.5"

  • Typ

    Unipivot

  • Effektive Masse (g)

    N/A

  • Effektive Länge (mm)

    251.6 / 236.1

  • Einstellbereich Kanalbalance (g)

    N/A

  • Überhangwinkel (deg)

    20.7

  • Überhang (mm)

    15.4

  • Gewicht (g)

    N/A

  • Offizieller Link