Hifiverse

Tonarme - Rega RB 303

Beschreibung, Bilder, technische Daten und Spezifikationen

Rega RB 303
Bildquelle - (c) Rega

The RB303 is a tonearm from Rega Research of England and the successor to the RB301, which Rega calls its most popular tonearm. It was introduced with the RP3 turntable and was also sold separately. Each arm is hand assembled and made in England.

Key specs that matter

The mounting distance from spindle centre to arm hole centre is 222 mm. Its mounting pillar requires a 25 mm hole, and the arm uses Rega's three-point fixing. The tracking force dial is marked from 0 to 3. Bias is set with a slider that has positions for 0.0, 1.0 and 2.0.

Engineering and use context

Rega gave the RB303 a completely redesigned arm tube, with a redistribution of mass that reduces stress on the bearings. According to Rega, many parts are delicate to meet low friction and minimum mass requirements. The arm has a balance weight, a cueing device with a lift/lower handle and a finger lift on the headshell. Bias settings of 1.0 to 1.5 suit most moving magnet cartridges and 1.5 to 2.0 most moving coil cartridges.

On any Rega turntable with three-point mounting it is a direct replacement without modification. For other turntables a template is supplied, with a cartridge alignment protractor printed on the same sheet. At least 250 mm of clearance is needed from the hole centre to the inside front of the turntable.

Pairing

A turntable drilled for the Rega three-point fixing, or a plinth drilled to the supplied template, is required. Moving magnet and moving coil cartridges are both covered by the bias scale.

Alternatives

The RB330 is a tonearm in Rega's current range.

Spezifikationen

  • Modellbezeichnung

    RB 303

  • Typ

    Gimbal

  • Effektive Masse (g)

    11

  • Effektive Länge (mm)

    237

  • Einstellbereich Kanalbalance (g)

    N/A

  • Überhangwinkel (deg)

    21,55

  • Überhang (mm)

    17,2

  • Gewicht (g)

    N/A

  • Offizieller Link