Hifiverse

Tonarme - Genuin Audio point

Beschreibung, Bilder, technische Daten und Spezifikationen

Genuin Audio point
Bildquelle - (c) Genuin Audio

The genuin audio point is a unipivot tonearm developed exclusively for genuin audio by Helmut Thiele, who describes it as the evolution of a tonearm he designed in 1978. genuin audio calls it a reinterpretation of the unipivot principle without the typical uncontrolled vertical tilt. At High End Munich it was listed at EUR 3,950. The German company, led by Thomas Wendt, was established in 1998.

Key specs that matter

Geometry is Baerwald/Löfgren, with an effective length of 254 mm, an overhang of 16.2 mm and an offset angle of 21.6 degrees. A carbon arm tube with a second, internal carbon tube carries a solid aluminium headshell bonded to the tube. VTA is adjustable at the base, azimuth by a transverse adjustable weight and tracking force by movable, damped counterweights. Anti-skating uses an adjustable weight on a micro-thread at the level of the unipivot bearing. Wiring is continuous high-purity silver, terminated with LEMO plugs.

Engineering and use context

Its bearing bush is made of ball bearing elements, with a geometry designed for precise guidance in the horizontal plane around exactly one fixed pivot point. The bearing tip is an adjusting screw with a welded and hardened bearing ball, and the centre of this ball remains the pivot point in every arm position. genuin audio specifies the bearing as free of play and yet damped, with no unipivot tilting.

On the base, the height-adjustable upper section is guided and damped by a solid M8 thread and three O-rings, which also give a rigid connection to the lower part and the sub-chassis. Two low-mounted counterweights set the basic balance, and a central setting weight gives the exact tracking force. Azimuth adjustment, anti-skating ring and stylus all lie on the zero level of the bearing. According to genuin audio, tracking forces therefore cannot twist the arm or change the tracking geometry.

Both ends of the carbon tube are bonded over a large area, to the counterweight carrier and to the mount of the bearing tip. Inside, a concentric carbon inner tube is connected to the headshell through an O-ring and glued at the pivot end to a free-swinging inner weight. A two-component damping gel fills the cavity between the tubes. The outer tube absorbs most low-frequency vibration energy, while the gel absorbs higher-frequency vibration of lower amplitude. Without interruption, the silver cable runs from the headshell pins to the connector plug for the genuin audio drive turntable.

Pairing

The point connects to the LEMO input socket of the genuin audio drive turntable. Its matching cartridge is the genuin audio sting. A tonearm base and connections for other turntables are available on request.

Alternatives

genuin audio makes no other tonearm.

Spezifikationen

  • Modellbezeichnung

    point

  • Typ

    Unipivot

  • Effektive Masse (g)

    N/A

  • Effektive Länge (mm)

    254

  • Einstellbereich Kanalbalance (g)

    N/A

  • Überhangwinkel (deg)

    21.6

  • Überhang (mm)

    16.2

  • Gewicht (g)

    N/A

  • Offizieller Link