The GRAVITON Ti Tonearm Dohmann Edition is a version of the Wilson Benesch GRAVITON Ti made for Dohmann Audio turntables, and it is the first OEM collaboration of this type for Dohmann. Wilson Benesch was founded in 1989 in Sheffield, England, and designed the GRAVITON Ti as part of its GMT analog system. A prototype was shown in the Dohmann room at Munich High End 2025, and the Dohmann Edition became available in July 2025. It is sold only through the Dohmann partner network. The standard GRAVITON Ti was priced at GBP 30,000, EUR 39,500 or USD 45,000, and Wilson Benesch offers matt titanium as standard with polished silver and polished gold titanium as upgrades.
Key specs that matter
Only one size is made, 416 mm long, with an effective length of 304.8 mm, mounting distance of 291.6 mm, 13.2 mm overhang and an 18° offset angle. Effective tonearm mass is 14 g, and Dohmann gives the cartridge weight range as all possible. Internal wiring is flexible high-purity 4N silver with Teflon insulation.
Engineering and use context
Its armtube is a single-piece moulded, tapered carbon fibre part in a quad-helix fibre orientation with a graphene matrix, unidirectional carbon fibre, a Rohacell core and viscoelastic damping. Data from Sheffield Hallam University shows a deflection of 0.003 mm at a stress of 8.5 MPa. The counterbalance is a three-part titanium structure, hollow at the front, tessellated through the middle and solid toward the pivot. Wilson Benesch makes it by Selective Laser Sintering and leaves some titanium powder un-sintered inside, where these powdered sections absorb energy. Almost no material sits above the pivot point, for a low centre of gravity.
A kinematic bearing gives three-point location on two zirconium balls and one conductive steel ball, with zero Brinelling, and the armwand can be changed in less than a minute. For VTA and SRA the pivot is raised or lowered through a collar set to slip mode and then locked on a hardened steel post. The piezo-driven VTA mechanism of the GMT system is not available on this edition. Azimuth is set coarsely with an offset counterweight and finely with a cross screw inside it. VTF uses the same two stages - the large counterweight moves fore and aft, and a smaller screw weight inside it sets fractions of a gram. For the Dohmann Edition the supporting structure was redesigned to fit a Dohmann floating armboard, and a Mk3 Dohmann Advanced Composite Armboard is supplied.
Pairing
A Dohmann turntable with a floating armboard is required. Alignment is preset for Wilson Benesch cartridges, and other cartridges are aligned through the headshell slots.
Alternatives
The Schröder CB-11 is another tonearm in the Dohmann Audio range.