The TB-100 is a tube phono equalizer from DS Audio of Japan, made for the brand's optical cartridges rather than for moving magnet or moving coil designs. An optical cartridge delivers a current from its photoelectric cells, and the TB-100 converts that current into a voltage, applies equalization and supplies the power the cartridge needs. Designed by Tetsuaki Aoyagi, it went on sale in late January 2025, and it works with every DS Audio optical cartridge from the entry models to the top of the range.
Key specs that matter
Rated output is 500 mV at 1 kHz from an output impedance of 700 ohm. DS Audio states a flat frequency response within -1 dB from 10 Hz to 70 kHz. Connections are unbalanced only, with one stereo RCA input and two stereo RCA outputs. The chassis measures 440 mm wide, 150 mm high and 482 mm deep, with a weight of 18.7 kg. Prices were set at USD 20,000, GBP 17,500 and EUR 19,999.
Engineering and use context
The circuit runs on ECC82 (12AU7) dual triodes supplied as quad-matched sets, which DS Audio sorts with its own tools to keep the variation between tubes within 1%, or 0.1 dB. The layout is a symmetrical dual-mono, single-ended design with two stages per channel. One tube handles voltage amplification, and a second works as a low-impedance cathode follower that buffers the output. The current-to-voltage conversion at the input uses a precision wideband transformer. Each channel has its own ground and its own power transformer, and these feed separate analogue-regulated low-noise supplies. Every supply drives the LED of its channel and provides the negative bias voltage of that channel's photoelectric cell, so the light source and the sensor of the left and right sides never share a power circuit. Four selectable bass curves are provided, and the second output adds a fixed 20 Hz filter with a slope of 6 dB per octave.
Pairing
The TB-100 needs a DS Audio optical cartridge, for example the DS-W3 or the Grand Master, since a conventional cartridge cannot draw the light source supply it provides. Because it has no XLR outputs, the partner should be a preamplifier or integrated amplifier that takes single-ended line inputs. The two outputs make it possible to feed two components at once, or to choose between the plain output and the filtered one depending on the records being played.
Alternatives
For a partner with balanced XLR outputs as well as RCA, DS Audio makes the DS-W3 Equalizer.