Hifiverse

Phonovorstufen - Kondo Audio Note Japan GE-1

Beschreibung, Bilder, technische Daten und Spezifikationen

Kondo Audio Note Japan GE-1
Bildquelle - (c) Kondo Audio Note Japan

The GE-1 is a single-box stereo tube phono equalizer amplifier from Kondo Audio Note Japan. Audio Note designed it as the companion phono amplifier for the Overture integrated amplifier and the G-70 preamplifier, and states that it works with both tube and solid-state amplifiers. It arrived in late 2010 at USD 12,366, and the European list price is EUR 12,500. A 1.75 m ACc-PERSIMMON power cable is included.

Key specs that matter

Equalization is of the NF type. Gain is 34 dB. Two pairs of unbalanced RCA inputs present 47 kohm, and one unbalanced RCA output pair is specified for a minimum load of 20 kohm. RIAA deviation is ±0.5 dB (30 Hz - 20 kHz, excluding the low-cut filter), and noise is less than 0.5 mV. Three 6072 tubes are used in the audio circuit, with one 6X4 as rectifier. Power consumption is 16 W. Dimensions are 303 x 160 x 260 mm (W x H x D, excluding protrusions), and weight is 7.5 kg.

Engineering and use context

Its output circuit is a two-stage NF circuit followed by a cathode follower for a low output impedance. Audio Note built the phono section as a module, with short signal paths and hand wiring, and the NFB loop was taken into account in its layout. Four decoupling capacitors are placed around the module, and the NFB paths are kept to the shortest length.

In the power supply a cut core power transformer with minimal magnetic flux leakage is used, and its design was fixed with attention to vibration countermeasures. Ripple filter capacitors total 400 µF, and decoupling capacitors are about 500 µF per channel. Left and right decoupling is also separate for the cathode follower and the equalizer sections, and four signal loops are formed. The DC heater circuit uses a large bridge diode and audio grade TO3 transistors for a low-impedance DC line.

On the output stage the load resistance is selectable in three steps. Together with the input impedance of the preamplifier it forms a resultant impedance of 20 kohm, and this works with the output coupling capacitor as a low-cut filter against rumble. Parts include SSW silk silver wire, original silver foil capacitors in the NFB part, the original cut core power transformer, silver lead resistors, original RCA jacks and a pure copper sub-chassis.

Pairing

A moving coil cartridge requires a step-up transformer. The matching line stages are the G-70 preamplifier and the Overture integrated amplifier. A transistor preamplifier with an input impedance down to 20 kohm is within the specified load.

Alternatives

The Kondo GE-10i is the flagship phono amplifier, with a separate power supply chassis and 38 dB of gain.

Spezifikationen

  • Modellbezeichnung

    GE-1

  • Eingänge (symmetrisch)

    N/A

  • Eingänge (unsymmetrisch)

    2

  • MC-Eingangsimpedanz (stromgekoppelt) (Ω)

    N/A

  • MM/MC-Eingangsimpedanz (spannungsgekoppelt) (Ω)

    47 000

  • Ausgangsimpedanz (Ω)

    20 000

  • Verstärkung (dB)

    34

  • Genauigkeit der Wiedergabe-Entzerrungskurven (dB)

    N/A

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Klirrfaktor + Rauschen (%)

    N/A

  • Abmessungen (mm)

    303 x 160 x 260

  • Gewicht (kg)

    7.5

  • Offizieller Link