The 755 is a phono preamplifier from soulution, the brand of Spemot AG in Dulliken, Switzerland, and belongs to its 7 Series. It combines MC and MM phono stages with a volume control that can be switched on or off. With the volume control active, the 755 can drive power amplifiers directly in a phono-only system. Delivery includes a remote control, a power cord and the user manual.
Key specs that matter
Inputs are two MC (IN 1, IN 2) and one MM (IN 3). MC voltage gain is +72 or +78 dB and MM gain +60 or +66 dB (at 1 kHz), selectable per input. Input impedance is 10 - 1,000 ohms for MC and 47 - 47,000 ohms for MM, with MM capacitance of 0 - 750 pF. Internal bandwidth is DC - 1 MHz (-3 dB), rise time is 400 ns and THD+N is below 0.0006%. Main-Out is balanced XLR and unbalanced RCA, with a maximum output voltage of 16 Vrms and 8 Vrms respectively (at 100 ohms), a maximum current of 1 A and an output impedance of 2 ohms. Channel separation exceeds 105 dB. Power consumption is 60 W in operation and below 0.5 W in standby. Dimensions are 480 x 450 x 167 mm and weight is approx. 30 kg.
Engineering and use context
The 755 is an unbalanced dual mono design, with identical circuit boards for the left and right channels, including the MC stage. Its audio section is physically separated from the power supply units and the digital circuits, and these sections are shielded against each other. Input impedance is set per input with relay-switched high-precision metal foil resistors, also from the listening position by remote control. An RIAA-IEC subsonic filter and a mono mode can be activated.
Each channel has its own volume control resistor network, built from relay-switched metal foil resistors in 80 steps of 1 dB. While the level is being changed, a parallel Programmable Gain Amplifier (PGA) path carries the signal, and the signal path then returns to the resistor network. The output stage operates in class A with a 40 mA idle current. Its theoretical maximum current of 3 A is limited to 1 A by a protection circuit outside the signal path.
Two separate power supplies serve the audio section and the digital circuits, with a multi-stage filter network between them. More than 500,000 µF of capacitance sits in the audio supply. Rear-panel connections include a ground-lift switch, a LINK socket (RJ45) for start-up of other soulution components and an RS232 interface.
Pairing
Balanced cables are recommended for long runs to the power amplifier. Two turntables or tonearms with MC cartridges and one with an MM cartridge can be connected. With the volume control off, the 755 connects to a line preamplifier.
Alternatives
The 550 phono is the phono stage of soulution's 5 Series.