Hifiverse

Tonabnehmer - Takumi Recordplayer Myo MC

Beschreibung, Bilder, technische Daten und Spezifikationen

Takumi Recordplayer Myo MC
Bildquelle - (c) Takumi Recordplayer

Takumi's Myo is a low-output MC cartridge and the top model of its five-strong MC range, which runs from the Aka through the Kuro, Shiro and Kin. Takumi hand-assembles every model around the same generator layout, with square OCC coil formers, a polished diamond and a stiff cantilever, and changes the materials from step to step. In the Myo the cantilever is cut from sapphire. In Norway it is priced at NOK 30,100, and in Canada at CAD 3,950.

Key specs that matter

The nude diamond has a fine elliptical profile with radii of 5 and 15 µm, and the vertical tracking angle is 20 degrees. Square coils are wound from 6N OCC copper with an internal impedance of 4.7 ohm. Output is 0.28 mV at 5 cm/s, channel balance at 1 kHz stays within 0.3 dB and separation at 1 kHz exceeds 28 dB. Frequency response runs from 15 Hz to 28 kHz. Tracking ability at 315 Hz is 70 µm and dynamic compliance is 16 µm/mN. Tracking force spans 1.3 to 2.0 g, with 1.8 g recommended, and the body weighs 9 g.

Engineering and use context

Moving up the range, the materials change at every step. The Aka uses an aluminium cantilever with a bonded conical tip and a 5 ohm generator, the Kuro moves to boron with a nude elliptical diamond, and the Shiro keeps boron but adds the 6N OCC coils and the fine elliptical profile. The Kin replaces boron with ruby and keeps the Shiro stylus geometry, and the Myo takes the same diamond and coil set onto sapphire, a material Takumi says combines high rigidity with controlled damping. Norwegian prices climb with each step, from NOK 4,900 for the Aka to NOK 9,800 for the Kuro, NOK 16,100 for the Shiro and NOK 22,300 for the Kin. Takumi quotes an optimal working temperature of 23 degrees Celsius and asks for roughly 30 hours of playing time as break-in. The manufacturer warranty lasts two years.

Pairing

Takumi pairs the Myo with tonearms of medium effective mass, a match for the moderate compliance of its cantilever suspension. Given the very low output voltage, the Myo requires a phono stage with sufficient gain for moving-coil pickups, or alternatively a step-up transformer for MC use that lifts the signal for a moving-magnet input, and Takumi gives a recommended electrical load of 100 to 330 ohm for the stage. A fine elliptical tip rewards precise alignment and an accurately set tracking force on the arm.

Alternatives

The Takumi Kin sits one rung beneath the Myo among the brand's MC cartridges and costs about a quarter less in Norway.

Spezifikationen

  • Modellbezeichnung

    Myo MC

  • Typ

    MC

  • Nadel

    Nude Fine Elliptical, r/R = 5/15 µm

  • Gehäuse

    N/A

  • Nadelträger

    Sapphire

  • Spulen

    Square 6N OCC

  • Ausgangsspannung (mV@5cm/sec)

    0.28

  • Untere Grenzfrequenz +/- 3dB (Hz)

    15

  • Obere Grenzfrequenz +/- 3dB (Hz)

    28 000

  • Innenwiderstand (Ohm)

    4.7

  • Kanaltrennung (dB / 1,000 Hz)

    >28

  • Nadelnachgiebigkeit (×10-6cm/dyne at 100Hz)

    N/A

  • Empfohlene Abschlussimpedanz (Ohm)

    100 - 300

  • Empfohlene Tonarme

    N/A

  • Gewicht (g)

    9

  • Offizieller Link