Hifiverse

Tonabnehmer - Kondo Audio Note Japan IO-XP

Beschreibung, Bilder, technische Daten und Spezifikationen

Kondo Audio Note Japan IO-XP
Bildquelle - (c) Kondo Audio Note Japan

The IO-XP is a moving coil phono cartridge from Kondo Audio Note Japan of Tokyo. Kondo counts it as the company's sixth MC phono cartridge and bases it on knowledge accumulated since the first IO of 1979. It is the only cartridge in the current Kondo catalogue, which also lists the SFz and SFz-E step-up transformers and the GE-10i, GE-7i and GE-2i phono amplifiers. In Europe the IO-XP has been listed at EUR 9,500.

Key specs that matter

Cartridge type is moving coil with pure silver wire. Output level is 0.12 mV (1 kHz, 5 cm/sec). Channel balance is lower than 1 dB (1 kHz), and channel separation is over 25 dB (1 kHz). Internal impedance is 1 ohm. Compliance is 6.0 x 10-6 cm/dyne. Recommended stylus pressure is 1.7 - 2.0 g, and weight is 12 g.

Engineering and use context

Kondo continues to use an alnico magnet in the IO-XP and cites its low magnetic resistance as the reason. For this model the assembly style and the magnetising method were reconsidered to obtain the maximum magnetic capacity from the alnico magnet.

On the mechanical side, the damping is set for more accurate tracing of the groove. Body shape and internal structure are devised to control the resonance of the main body.

Kondo's SFz MC step-up transformer has a pure silver (99.99%) multi-layer balanced winding on a core of 0.1 mm permalloy laminations. It has two primary terminals - 1.5 ohms for cartridges of 1 to 10 ohms and 30 ohms for cartridges of 11 to 40 ohms. Step-up ratio is 34 dB on the 1.5 ohm terminal and 20 dB on the 30 ohm terminal, with 47 kohms as the recommended load. Its output cable is the Ls-41 pure silver cable.

Pairing

A step-up transformer for 1 ohm cartridges or an MC phono stage with very high gain is required. The matching step-up transformer is the Kondo SFz on its 1.5 ohm terminal, followed by a phono amplifier with a 47 kohm input such as the GE-10i, GE-7i or GE-2i. A tonearm of medium or high effective mass is required.

Alternatives

The earlier Kondo IO-M is an MC cartridge that also combines an alnico magnet with a silver coil.

Spezifikationen

  • Modellbezeichnung

    IO-XP

  • Typ

    MC

  • Nadel

    N/A

  • Gehäuse

    N/A

  • Nadelträger

    N/A

  • Spulen

    N/A

  • Ausgangsspannung (mV@5cm/sec)

    0.12

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Innenwiderstand (Ohm)

    1

  • Kanaltrennung (dB / 1,000 Hz)

    25

  • Nadelnachgiebigkeit (×10-6cm/dyne at 100Hz)

    6.0

  • Empfohlene Abschlussimpedanz (Ohm)

    N/A

  • Empfohlene Tonarme

    N/A

  • Gewicht (g)

    12

  • Offizieller Link