The DS-W3 is an optical phono cartridge from the Japanese company DS Audio. Instead of a coil or magnet, it converts stylus movement into an electrical signal photoelectrically, with a light source and a photodetector reading the motion of the cantilever. Because of this principle it needs a dedicated optical equalizer rather than an ordinary MM or MC phono stage, and DS Audio sells the DS-W3 Equalizer as its partner. The previous generation of the W line carried the DS-W2 name.
Key specs that matter
The stylus has a line contact profile and sits on a boron cantilever. Output is 70 mV or more, against 40 mV in the earlier design, and channel separation is at least 27 dB at 1 kHz. The cartridge weighs 7.9 g. Tracking force runs from 1.85 to 2.05 g, and DS Audio recommends 1.95 g. In Japan the cartridge is priced at JPY 495,000 including tax.
Engineering and use context
DS Audio mills the one-piece housing out of A5052 aluminium alloy. Inside, each channel has its own LED and its own photodetector, placed independently, and DS Audio credits this layout with the higher output and better signal-to-noise ratio. The shield plate is made of 99.9% pure solid beryllium, and it is smaller than before and more than 50% lighter. Internal wiring is 1.6 times thicker than in the previous model to lower its impedance. A photoelectric cartridge also needs power for its light source, which the equalizer supplies through the tonearm cable, so the cartridge and its equalizer always operate as a pair.
Pairing
The natural partner is the DS-W3 Equalizer, priced at JPY 935,000. It delivers 500 mV at 1 kHz from a 120 ohm output, and DS Audio asks for a preamplifier input impedance of 10 kohm or more. Signal enters on RCA, and it leaves through either two RCA sockets or two XLR sockets, chosen as balanced or unbalanced output, so a balanced preamplifier connects directly. The low-frequency cut-off has four selectable settings, and the output can be switched between four patterns. Its circuit board is 2.0 mm thick with 70 µm copper foil, up from 1.6 mm and 35 µm in the DS-W2 unit, and resistor leads are hand-twisted with extra wiring on the back of the board. The box measures 450 x 120 x 435 mm and weighs 13.5 kg. The DS Audio TB-100 tube equalizer also accepts any DS Audio optical cartridge.
Alternatives
Higher in the same optical range, DS Audio offers the Grand Master cartridge.