The AT33xEN is a dual moving coil (MC) stereo cartridge from Audio-Technica of Japan and the entry stereo model of the AT33x series. Five models make up the series - the stereo AT33xMLB, AT33xMLD and AT33xEN and the mono AT33xMONO/I and AT33xMONO/II. It is the first full model change of the AT33 line since 2014, a line that Audio-Technica traces back to the AT34 headshell-integrated MC of 1977. It went on sale in October 2025 at USD 699. Each cartridge is hand-crafted in Japan and shipped in a plastic-free paper package.
Key specs that matter
Stylus is a 7.6 x 17.8 µm nude elliptical on a duralumin tapered pipe cantilever. Output voltage is 0.4 mV (1 kHz, 5 cm/s), channel separation is 27 dB (1 kHz) and output balance is 1.0 dB (1 kHz). Frequency response is 20 Hz - 40 kHz. Coil impedance is 12 ohms (1 kHz), DC resistance is 12 ohms and coil inductance is 26 µH (1 kHz). Recommended load is 100 ohms or more with a head amplifier. Static compliance is 21 x 10-6 cm/dyne, and dynamic compliance is 6 x 10-6 cm/dyne (100 Hz). Tracking force is 1.8 - 2.2 g (2.0 g standard), at a vertical tracking angle of 19°. Dimensions are 16.1 x 16.6 x 26.1 mm (H x W x D), and weight is 10.1 g.
Engineering and use context
Audio-Technica uses its dual moving coil structure with independent left and right coils. Both coils are wound with PCOCC (Pure Copper by Ohno Continuous Casting), which has no crystal grain boundaries in the direction of signal transmission. A neodymium magnet and a permendur yoke form a strong field in the magnetic gap that holds the coils. Its cantilever is duralumin, harder than common aluminium, and tapers toward the tip for better high-frequency reproduction.
For the AT33x series the cartridge base is die-cast zinc, used here by Audio-Technica for the first time for its rigidity and density. Aluminium and a high-rigidity polymer complete the composite body, and the three materials distribute resonance across the whole body. A newly developed suspension and rubber damper set the dynamic compliance slightly lower than in other Audio-Technica cartridges, for use with a variety of tonearms. Terminal pins carry thicker gold plating than earlier models to lower contact resistance. Threaded M2.6 mounting holes allow direct mounting on integrated tonearms.
Supplied are a non-magnetic screwdriver, two washers, a stylus protector, a brush and M2.6 screws in 8.0, 10.0 and 13.0 mm lengths, two of each.
Pairing
An MC phono stage or a head amplifier with a load of 100 ohms or more is required. An MC step-up transformer into an MM input is the other option.
Alternatives
The AT33xMLD is the next stereo model of the series, with a microlinear nude stylus on the same duralumin tapered pipe cantilever.