The MAY DAC KTE is a full discrete R2R digital-to-analogue converter from Holo Audio, designed by Jeff Zhu and built without an off-the-shelf DAC chip. KTE stands for Kitsune Tuned Edition, the Level 3 version of the MAY above Level 1 and Level 2. It has 1.5 mm pure OCC silver internal wiring, hand-selected DAC modules under copper shield covers, silver and rhodium plated faston connectors at the IEC inlet, a Red Nano fuse, KTE capacitors in place of the Vishay types and a copper Kitsune fox emblem on the top panel. The US price is USD 5,598.
Key specs that matter
Coaxial 1, coaxial 2, optical and AES inputs accept PCM 44.1 - 192 kHz (24-bit) and DSD64 (DoP). USB accepts PCM 44.1 kHz - 1.536 MHz (32-bit), DSD64 - DSD512 (DoP) and DSD64 - DSD1024 (native). Two I2S inputs take PCM up to 1.536 MHz and DSD64 - DSD1024. In PCM 48 kHz NOS mode THD+N is 0.00017% at 1 kHz (-115 dB) and DNR is 130 dB, with 2.9 Vrms at 27 ohms from RCA and 5.8 Vrms at 54 ohms from XLR. For DSD128 Holo specifies THD+N of 0.00025% (-112 dB) and DNR of 115 dB. Main box and power chassis each measure 430 x 300 x 55 mm (W x D x H), and total weight is 18 kg. Mains input is 220-230 V or 110-115 V, and consumption is 60 W.
Engineering and use context
Its dual mono layout gives each channel a dedicated DAC module and a dedicated O-type flatwire transformer, hand-made for this DAC and housed in the power supply chassis. Multi-stage regulation uses Rubycon ZLH and Panasonic FC capacitors. According to Holo, linear compensation corrects the errors caused by resistor tolerance in the ladder. A PLL and FIFO buffer with a 0.1 Hz third-order low-pass act against jitter, clocked by a Crystek CVHD-957 femtosecond VCXO.
On the USB side an upgraded module with an FPGA, the Titanis 2.0 circuit, custom firmware and two XMOS xu208 chips targets the USB eye pattern, latency and jitter, and the input is ground-isolated. Each of the two HDMI-I2S inputs uses a custom four-way circuit instead of an LVDS chip and has a configurable pinout. A dedicated circuit reduces the click when the stream switches between DSD and PCM. NOS mode passes the original data to conversion without oversampling, while OS PCM and OS DSD modes oversample any input to PCM or DSD. A soft-start circuit sits behind the front power button, and the display shows CD track time on S/PDIF inputs. Control comes from a CNC-machined aluminium remote, and no mains cable is supplied.
Pairing
The MAY has no volume control, and a preamplifier or an integrated amplifier is required. Its XLR outputs connect to balanced line inputs. I2S sources with an HDMI-I2S output connect through the configurable I2S inputs.
Alternatives
The Holo Audio Spring 3 is a single-chassis discrete R2R DAC below the MAY in the range.