The DAC1 Mk II is a stand-alone D/A converter from Merason, a Swiss brand of niedal audio lab AG. Its circuit is fully balanced, with two Burr Brown converter chips and discrete analogue stages. Housing, front panel, control knobs and printing are made in Switzerland, and component assembly, final assembly, commissioning and testing take place there too, at the production site in Burgdorf. Silver, black and champagne finishes have been offered.
Key specs that matter
Conversion uses two Burr Brown 1794A chips with a discrete I/V stage. Digital inputs are USB (USB Audio Class 2.0), coaxial S/PDIF on RCA, Toslink and AES. Supported formats are 44.1 and 48 kHz at 16 or 24 bit, plus 88.2, 96, 176.4 and 192 kHz at 24 bit, with 176.4 kHz on USB only. DSD is not listed. Maximum output is 3 V RMS balanced and 1.5 V RMS single-ended. Frequency response is 20 Hz - 20 kHz (±0.3 dB), THD+N is below 0.01% and SNR is above 120 dB. Power supply is 230 V AC, 50 - 60 Hz, with a consumption of 30 W. Dimensions are 450 x 100 x 290 mm (W x H x D), and weight is 5.5 kg.
Engineering and use context
Each channel has its own 1794A, which Merason credits with a 5 dB gain in dynamic range. A discrete stage converts the current output of the chips into a voltage, and this signal is buffered in class A before reaching the output. Because the design is fully balanced, four independent channels run from the two converters to the outputs.
Every functional block has its own supply, twelve in total. Each pair of output channels is powered by a separate linear supply with an oversized transformer.
On the USB input, the receiver is based on Amanero technology and uses two precision oscillators for low jitter. Capacitive isolator ICs galvanically isolate the USB signal from the rest of the circuit. Signals at the other three inputs are also galvanically isolated, using transformers and capacitors, and are de-jittered.
Its front panel carries a power switch, an input selector button and LEDs for a locked signal, a detected USB signal and the selected input. Merason specifies an ambient temperature of 10 - 30 °C and humidity up to 80%, non-condensing. In use the unit runs about 20 K above room temperature, and its top panel dissipates the heat.
Pairing
The XLR outputs match a preamplifier or integrated amplifier with balanced inputs, and the RCA outputs match single-ended inputs. A computer or streamer connects over USB, and a CD transport over AES, coaxial or Toslink. DSD files require conversion to PCM.
Alternatives
The DAC 2 is Merason's step-up converter, with the same two 1794A chips, 3.5 V RMS balanced output and THD+N below 0.006%.