Hifiverse

Subwoofer - Fyne Audio F3-10

Beschreibung, Bilder, technische Daten und Spezifikationen

Fyne Audio F3-10
Bildquelle - (c) Fyne Audio

The F3-10 is the middle model of the three F3 Series subwoofers from Fyne Audio, placed between the F3-8 and the F3-12. Fyne designs the series for home theatre, with a Bass Boost mode for LFE, and the stereo phono inputs also allow use in a two-channel system. Black Ash is the finish, the grille is removable, and the UK price is GBP 499.99 per unit.

Key specs that matter

A 250 mm front mounted driver is powered by a 475 W DDX Direct Digital amplifier. Enclosure type is vented, down-firing, with an enclosure volume of 34 litres. Low frequency response is 32 Hz (-6 dB, typical in room), and Bass Boost adds 3 dB over 35 - 70 Hz. Inputs are 2 x phono L & R stereo and 1 x mono LFE. The input filter is an 80 Hz 2nd order low pass with LFE provision. Mains voltage is 220 - 240 V, 50/60 Hz, maximum power consumption is 240 W, and standby consumption is below 0.5 W (ErP). Dimensions are 410 x 340 x 393 mm (H x W x D, including feet), and net weight is 16 kg.

Engineering and use context

DDX is a patented, all-digital, high efficiency amplifier technology. Fyne describes it as similar to a standard Class D amplifier, with higher power, better efficiency and lower RFI output. A DSP engine controls the low pass filters for the LFE and stereo inputs, automatic dynamic range management and overload protection, and it also provides the Bass Boost function.

Its cone is formed from a mix of fibres for a light and stiff diaphragm. According to Fyne, the soft rubber roll surround and the deep coil and motor assembly give extensive excursion and high power handling. Each end of the large diameter port has a mathematically derived flare profile for low turbulence. Cabinets are built from heavyweight braced MDF panels, and large compliant feet couple the subwoofer to the floor.

On the amplifier panel are a sub level control, a 0/180-degree phase switch, the Bass Boost switch and an input switch. In NORMAL mode the input switch engages the internal 80 Hz low pass filter, and in LFE mode it switches the filter out. In AUTO power mode it stays in standby until an input signal is detected and returns to standby after approximately 10 minutes without signal, while ON keeps it permanently powered. The 12 V trigger input is a 3.5 mm jack with the centre pin positive.

Pairing

An AV receiver connects from its SUB OUT to the LFE input, with the input switch set to LFE. A stereo preamplifier with a spare set of outputs connects to the L and R inputs, with the switch set to NORMAL. A 12 V trigger output on the receiver allows the subwoofer to power on with the system.

Alternatives

The F3-12 is the larger F3 Series subwoofer, with a 300 mm driver, 520 W of DDX amplification and a 53 litre enclosure.

Spezifikationen

  • Modellbezeichnung

    F3-10

  • Untere Grenzfrequenz +/- 3dB (Hz)

    35

  • Obere Grenzfrequenz +/- 3dB (Hz)

    70

  • Empfindlichkeit (dB at 1 W/1m)

    N/A

  • Impedanz (Ohms)

    N/A

  • Verfügt über interne Verstärkung

    Ja

  • Endverstärker (W)

    475

  • Größe (sm)

    41.0 x 34.0 x 39.3

  • Gewicht (kg)

    16

  • Offizieller Link

Weitere Komponenten