Hifiverse

Subwoofer - Børresen Acoustics BM3

Beschreibung, Bilder, technische Daten und Spezifikationen

Børresen Acoustics BM3
Bildquelle - (c) Børresen Acoustics

The BM3, or Bass Module 3, is an active subwoofer from Børresen Acoustics, the Danish loudspeaker brand of Audio Group Denmark, developed by Flemming Erik Rasmussen and Michael Børresen. It was launched at the end of January 2026 at EUR 18,000, or USD 21,000, per unit. Instead of a ported or sealed enclosure it uses a folded-dipole design that radiates through openings on its front and back.

Key specs that matter

Drivers are four Børresen DCC8 Neo long-stroke bass units with natural rubber surrounds. Frequency response is 20 Hz - 120 Hz. The analogue low-pass filter is adjustable from 33 to 91 Hz (63 Hz default) with a fixed 24 dB/octave slope. Gain is adjustable from 10 to 28 dB, and the volume control has 56 steps of 0.5 dB. Phase is variable from 20 to 160 degrees, with a separate phase invert. Line inputs have 10 kohms input impedance and accept 9 V RMS (mono) or 4.5 V RMS (stereo) maximum. Power consumption is below 1 W in standby and below 30 W at idle, on 100-240 V mains with 10 A maximum current. Height, width and depth are 585 x 399 x 429 mm, and weight is 46.4 kg.

Engineering and use context

Børresen calls the folded dipole a velocity converter rather than a pressure generator. Its output goes forward and backward in opposite phase, with lateral cancellation that limits side-wall reflections. Inside is the latest version of Pascal class D amplifier technology with high-speed UMAC switching modulation. According to Børresen, UMAC requires less filtering and has lower output impedance. A power-factor-corrected resonant-mode switching power supply runs with sine-wave behaviour and raises its operating frequency as power demand increases.

Derived from Aavik amplifier designs, the low-pass crossover is fully analogue with no signal delay, and it can be switched off for an external crossover. Noise reduction uses 36 active Tesla coils, 72 active square Tesla coils, three dither circuits and three anti aerial resonance coils. Each unit is assembled by hand in Aalborg and finished in high gloss black with carbon details.

Pairing

A preamplifier output or the low-pass output of an external crossover is required. Two sets of single-ended RCA line connections allow daisy chaining, and mono or stereo mode is selectable. The rear panel also carries two DC trigger connections, an RS-232 port for software updates and an unswitched mains outlet.

Alternatives

The Børresen Bass Module 2 is the other model in the Børresen bass module range.

Spezifikationen

  • Modellbezeichnung

    BM3

  • Untere Grenzfrequenz +/- 3dB (Hz)

    20

  • Obere Grenzfrequenz +/- 3dB (Hz)

    120

  • Empfindlichkeit (dB at 1 W/1m)

    N/A

  • Impedanz (Ohms)

    N/A

  • Verfügt über interne Verstärkung

    Ja

  • Endverstärker (W)

    2 x 300

  • Größe (sm)

    58.5 x 39.9 x 42.9

  • Gewicht (kg)

    46.4

  • Offizieller Link