The Anthra W12 is the mid-sized subwoofer of the Monitor Audio Anthra series, between the W10 and the W15. Monitor Audio aims it at mid to large home cinema systems that use one subwoofer or several. It lists at USD 3,299 in the United States, a UK price of GBP 1,900 was quoted at launch, and the cabinet comes in Satin White or High Gloss Black.
Key specs that matter
It is an active sealed-cabinet design with one 305 mm high linear-excursion triple suspension driver, rated for 50 mm of peak-to-peak excursion. On 240 V mains the high-efficiency Class-D amplifier is rated at 1,700 W instantaneous and 900 W continuous short-term, and on 120 V at 1,325 W and 700 W. Frequency limits are 16 Hz (-6 dB) at the bottom and 400 Hz (-6 dB) at the top with the low-pass filter off. Each side of the cube measures 374 mm without feet, and weight is 28.56 kg. Power consumption is 200 W, mains input is universal 85-265 V AC, and Monitor Audio gives a 5-year warranty.
Engineering and use context
In Monitor Audio's terms, instantaneous output is the maximum RMS output for an instantaneous signal, and continuous short-term output is a sine wave sustained for 10 seconds. Amplifier and power supply share one design process, aimed at efficiency and lower distortion. Every Anthra driver has a C-CAM cone, ceramic-coated aluminium-magnesium with a higher resistance to bending stress, and Rigid Surface Technology II, used on a Monitor Audio subwoofer cone for the first time in this range to raise cone rigidity. Large motor assemblies sit behind the cone.
Its enclosure is braced 25 mm MDF with a 36 mm front baffle and 19 mm internal walls, and the cloth grille is held by magnets. A 28-bit, 50 MIPS DSP follows an autoranging input that combines a 10 Vrms maximum input level with low noise on small signals. Low-pass frequency is set between 20 and 200 Hz with roll-off from -3 to -48 dB per octave. Phase runs from 0 to 360 degrees at the crossover point. Three predefined EQ curves sit alongside three custom curves, each with 8 bands of peaking, high shelf, low shelf and high-pass filters. A full-colour LCD and rotary dial on the back panel cover basic setup and preset selection, and MaestroUnite gives access to DSP configuration and multi-sub setup.
Pairing
A preamplifier, AV processor or receiver with a line-level subwoofer or LFE output is required. Inputs are stereo RCA, with mono or LFE on the connector marked LFE, and balanced XLR for mono or LFE. RCA and XLR outputs with unbuffered throughput allow up to three further Anthra subwoofers to be linked.
Alternatives
The Monitor Audio Anthra W15 is the largest model of the series, with a 381 mm driver and a 2,500 W instantaneous Class-D amplifier.