The Airmotiv XS10 is a powered subwoofer in Emotiva's Airmotiv XS family, announced together with the Airmotiv T3+ and C3+ speakers with deliveries scheduled for the end of August 2022. Its price was USD 599. The family has four models, the XS8, XS10, XS12 and XS15, with 203, 254, 305 and 381 mm drivers, identical controls, and more power and deeper response in the larger models.
Key specs that matter
The driver is a 254 mm heavy duty long throw unit with a 51 mm copper voice coil. Amplifier power is 350 W RMS from a Class A/B amplifier. Frequency response is 26 Hz - 200 Hz (±3 dB). Inputs are a single balanced XLR and two unbalanced RCA inputs (Sum and LFE) that are summed internally. Controls are crossover, phase, volume and LF Boost. The built-in crossover is a 12 dB/octave low-pass filter with a highest setting of 150 Hz. LF Boost runs from approximately -3 dB to +9 dB at 30 Hz. Mains is 115 VAC/60 Hz or 230 VAC/50 Hz, set with a line voltage selector. Dimensions are 438 x 362 x 445 mm (H x W x D, including feet), and the boxed weight is 29.9 kg.
Engineering and use context
Emotiva builds the driver on a cast aluminium frame with a non-pressed paper cone reinforced with aramid fibres and an SBR rubber surround. Its motor has a large diameter, double stacked ferrite magnet, and the voice coil is wound on an aluminium former. Cooling comes from a vented pole piece, vents under the spider and forced air cooling. Loading is a rear tuned slot port in a heavily braced HDF cabinet.
An oversized toroidal power transformer supplies the amplifier, and heat sinks for it sit on the rear panel. Protection is a multi-stage low-distortion limiter. A power mode switch has On and Auto settings, and in Auto the XS10 turns on when audio is detected and returns to standby after several minutes without signal. The status indicator is green when on and red in standby. On the rear panel are also the IEC power receptacle, a drawer-type fuse holder and the AC power switch. The front bezel has several coats of satin black lacquer behind a removable sculpted fabric grille, while sides and rear are covered in textured vinyl. Anti-slip rubber feet are permanently attached. Warranty is five years.
Pairing
A line-level subwoofer or LFE output from an AV receiver, processor or preamplifier is required, over XLR or RCA. There are no speaker-level inputs.
Alternatives
The Airmotiv XS12 is the next size up, with a 305 mm driver, 500 W RMS and a response of 24 Hz - 200 Hz (±3 dB).