The SGM 10 is a mid-field reference monitor from Tannoy and the most compact model of the Super Gold Monitor series. Tannoy presents the series as a modern evolution of the classic Super Gold designs used in professional studios in the 1970s and 1980s. The range has three models, SGM 10, SGM 12 and SGM 15, and each number gives the diameter in inches of its Dual Concentric driver.
Key specs that matter
This is a two-way design on one 254 mm (10 in.) Dual Concentric driver. Its LF section has a paper pulp cone with a twin roll impregnated fabric surround and a 52 mm edge-wound voice coil. In the centre sits a 33 mm aluminium/magnesium alloy HF dome, also with an edge-wound voice coil. Frequency response is 40 Hz - 30 kHz (±6 dB), and the crossover frequency is 1.2 kHz. Sensitivity is 89 dB (1 W/1 m) into a nominal 8 ohms. Recommended amplifier power is 20 - 200 W, and power handling (IEC) is 100 W continuous, 400 W peak. Dimensions are 350.5 x 309 x 523.2 mm, and net weight is 18.5 kg.
Engineering and use context
The Dual Concentric driver uses modern ferrite magnets with copper demodulation rings. As a point source, the SGM 10 performs equally well placed horizontally or vertically. Its crossover is a hard-wired passive network with a low-loss second-order low pass and a first-order high pass, and it is bi-wired.
On the front panel, trimmed in gold anodised aluminium, are two treble controls. Treble Energy adjusts the HF driver over its entire range with ±3 dB of shelving adjustment, while Treble Roll-Off only shapes the response above 5 kHz with a slope from +2 to -6 dB per octave. Its front-mounted twin distributed port allows near-wall or soffit placement.
Tannoy builds the high-density cabinet from 19 mm particle board and MDF with heavily damped plywood internal bracing. This bracing incorporates Differential Materials Technology (DMT) to couple the driver to the cabinet. The finish is walnut veneer with a nylon grille cover. Five 4 mm Tannoy binding posts, plated in 24 ct gold, allow single-wire, bi-wire and bi-amp connection, and bi-wire bridge connectors, wood wax and rubber feet come in the accessory pack.
Pairing
Tube and solid-state amplifiers within Tannoy's recommended power range can drive the 8 ohm load. The separate HF and LF terminals allow bi-wiring or bi-amping with two identical stereo or power amplifiers.
Alternatives
The Tannoy SGM 12 is the next model up in the Super Gold Monitor series, with a 12-inch Dual Concentric driver.