The Project Everest DD67000 is a three-way floorstanding loudspeaker from JBL of Northridge, California, with refinements over the Project Everest DD66000 that JBL developed for its 60th anniversary. It belongs to the JBL Project loudspeakers, a line that began with the Hartsfield of 1954 and continued through the Paragon, the Everest DD55000 of 1986, several K2 models and the DD66000. JBL calls the configuration an augmented two-way. The DD67000 dates from 2012, and finishes are rosewood or maple.
Key specs that matter
Two 380 mm 1501AL-2 woofers with pure pulp sandwich cones work below a 100 mm 476Be beryllium compression driver, and a 25 mm 045Be-1 beryllium compression driver covers the ultrasonic range. Crossover frequencies are 150 Hz (LF1, 6 dB/octave), 850 Hz (LF2, 24 dB/octave) and 20 kHz (UHF, 24 dB/octave). Frequency response is 30 Hz - 60 kHz (-6 dB, half space) and 45 Hz - 60 kHz anechoic. Sensitivity is 96 dB (2.83 V/1 m). Nominal impedance is 8 ohms, with 5.0 ohms at 85 Hz and 3.0 ohms at 40 kHz. Horn directivity is 100 x 60 degrees (HF) and 60 x 30 degrees (UHF). Each cabinet measures 965 x 1109 x 469 mm (H x W x D) including feet and weighs 137 kg without grille or 142 kg with it.
Engineering and use context
Both woofers operate below 150 Hz, but only one extends up to the midrange crossover, and above it the 476Be and its horn work unassisted to 20 kHz. Each 1501AL-2 has a long 100 mm edge-wound aluminium voice coil in an underhung radial field from an Alnico 5DG magnet, with a shorting ring and a top plate of alternating copper-steel laminations. Its coil is wound for double impedance, so the pair keeps an 8 ohm system impedance. The cone has a foam injection core and an accordion-pleated cloth surround, with dual inverted Nomex spiders.
Inside the 476Be, a 98% pure beryllium diaphragm with an integral diamond-pattern surround works into a coherent-wave four-slot phasing plug, and the neodymium motor has a copper-sleeved polepiece. The 045Be-1 diaphragm is under 0.04 mm thick with a mass of 0.1 g, and its aluminium ribbon voice coil is wound without a former. Its curved MDF baffle forms the sidewalls of the main horn, with SonoGlass horn lips top and bottom. An inner 19 mm Finland birch plywood baffle sits behind an outer baffle covered in carbon fibre cloth. Two 100 mm flared rear ports are tuned to 31 Hz.
Pairing
JBL specifies amplifiers of 100 - 500 W with very high current capacity that can drive a low-impedance load. Front panels carry LF and HF level controls (Low, Mid, High), drive mode bars for bi-amping and left/right orientation bars.
Alternatives
The JBL Project Everest DD65000 is the related floorstanding model with magnesium compression drivers and a 750 Hz midrange crossover.