Hifiverse

Standlautsprecher - Børresen Acoustics Børresen Z5

Beschreibung, Bilder, technische Daten und Spezifikationen

Børresen Acoustics Børresen Z5
Bildquelle - (c) Børresen Acoustics

The Børresen Z5 is the top model of the Børresen Z-series, a floorstanding loudspeaker with seven drive units. Børresen developed the Z-series to use more conventional components than the 0-series. Its parts are either taken over from the 0-series, redesigned, or derived from the company's own driver research.

Key specs that matter

The driver complement is one Børresen planar ribbon tweeter, two 127 mm (5 in.) bass/midrange drivers and four 203 mm (8 in.) bass/midrange drivers. Frequency response is 25 Hz - 50 kHz. Sensitivity is 90 dB (1 W), impedance is 4 ohms, and recommended amplifier power is over 50 W. Each speaker measures 151.0 x 23.0 x 70.0 cm (H x W x D) and weighs 75.0 kg. Finishes are black or white satin paint.

Engineering and use context

For the Z-series Børresen designed a new, less costly magnet system rather than the patented iron-free system of the 0-series, which reaches 0.04 mH, about ten times below common driver systems. Each bass/midrange driver of the Z5 has an 8 mm voice coil and an induction of 0.06 mH. According to Børresen, its linearised magnetic field makes the driver less affected by its own movement.

All six cone drivers use the Børresen membrane, a composite of two layers of thin carbon on both sides of a 4 mm Nomex honeycomb core. One membrane weighs 5.5 g.

The RP94 Ribbon Planar Tweeter operates from approximately 2.5 kHz upwards. This closed ribbon has an efficiency of 94 dB and a moving mass of 0.01 g, and no transformer is used. Finite element methods were applied to linearise its magnetic flux field.

Unlike the serial filters of the 0-series, the Z-series uses a parallel crossover. It is built with the same components as the 0-series crossover and is mechanically stable to minimise its own resonance. At the base, a ground cross plate with adjustable feet is prepared to stand on Ansuz Darkz resonance control, where three titanium balls separate the discs.

Pairing

An amplifier stable into 4 ohms is required. Audio Group Denmark lists the Aavik I-588 integrated amplifier with the Z5. The matching cable and resonance control are Ansuz Speakz Titanium and Ansuz Darkz Z2 Signature.

Alternatives

The Børresen Z3 is a smaller floorstanding model of the Z-series.

Spezifikationen

  • Modellbezeichnung

    Børresen Z5

  • Untere Grenzfrequenz +/- 3dB (Hz)

    25

  • Obere Grenzfrequenz +/- 3dB (Hz)

    50 000

  • Empfindlichkeit (dB at 1 W/1m)

    90

  • Impedanz (Ohms)

    4

  • Anforderungen an den Endverstärker (W)

    >50

  • Verfügt über interne Verstärkung

    k. A.

  • Leistung der internen Verstärkung (W)

    N/A

  • Größe (sm)

    151,0 x 23,0 x 70,0

  • Gewicht (kg)

    75

  • Offizieller Link