The BC150 is a floorstanding loudspeaker in the Reference Line of Burmester Audiosysteme GmbH, the Berlin company founded in 1977 by Dieter Burmester. For the BC150, existing elements of the BC350 were taken as a basis and translated into a more compact design. Design and manufacturing of all elements installed in it are done by hand by Burmester employees, and Burmester sources 95% of the materials for its loudspeakers from local manufacturers and fabricators.
Key specs that matter
It is a three-way bass reflex design. A 32 cm woofer with a sandwich cone and a motor with dual magnets is mounted in the side of the cabinet, the 18 cm midrange transducer has an elliptic phase plug and voice coil, and the tweeter is an Air Motion Transformer (AMT), with a second AMT on the rear. Crossover frequencies are 155 Hz and 1800 Hz. Transmission range is 34 Hz - 20 kHz (±3 dB), sensitivity is 88.5 dB (2.83 V/1 m) and nominal impedance is 3 ohms. Nominal load capacity is 400 W (DIN EN 60268-5). Dimensions are 309 x 1433 x 601 mm (W x H x D), and weight is 180 kg.
Engineering and use context
Burmester derived the front AMT from the one used in the BC350 and tailored it for the BC150. Its lightweight, large-area foil membrane sits in a powerful magnetic field. The rear AMT is adjustable, and according to Burmester it increases the dispersion of the speaker.
Inside the midrange driver, a new oval-shaped voice coil increases the dimensional stability of the lightweight membrane. Its woofer is also derived from the BC350 bass driver and has a long-stroke diaphragm. Its bass reflex port is flow-optimised and made of carbon fibre.
Cabinet construction starts from a solid aluminium frame, and stiffeners made of aluminium tubes are used inside. All drivers are braced against the cabinet with high preload forces. As a damping system, the cabinet is coated with a 4 mm steel plate and a special plastic. Relevant components are decoupled from each other, including the crossover, which sits in its own housing chamber, and the feet further stabilise the cabinet.
Internal wiring is Burmester speaker cable with generous cross sections. Decorative elements are interchangeable in colour and material and can be changed at the installation site.
Pairing
An amplifier rated for low-impedance loads is required. The terminals allow bi-amping with two power amplifiers. For use with one amplifier, solid gold-plated bridges of high-purity oxygen-free copper are supplied.
Alternatives
The BC350, which Burmester calls its flagship, is the larger floorstanding loudspeaker in the range.