The Avior II is a three-way floorstanding loudspeaker from Rockport Technologies of South Thomaston, Maine. It keeps the form of the original Avior but has a new waveguide-mounted beryllium tweeter, Rockport's latest generation of midrange and bass drivers and an entirely redesigned crossover, and Rockport calls the result essentially a completely new loudspeaker. The price was USD 38,500 per pair.
Key specs that matter
The driver complement is a waveguide-mounted 25 mm beryllium dome tweeter, a 152 mm carbon fibre sandwich composite midrange and two 229 mm carbon fibre sandwich composite woofers. Frequency response is 25 Hz - 30 kHz (-3 dB). Sensitivity is 89.5 dB SPL (2.83 V), nominal impedance is 4 ohms and minimum amplifier power is 50 W. Each speaker measures 1181 x 381 x 622 mm (H x W x D) and weighs 99.8 kg.
Engineering and use context
According to Rockport, mounting the tweeter in a waveguide improves its acoustic impedance match at the low end of its range, lowers its distortion and improves dispersion at the midrange/tweeter crossover point. The cone diaphragms of the midrange and bass drivers use carbon fibre fabric skins pre-impregnated with a toughened epoxy resin and consolidated to a Rohacell core under heat and pressure in aluminium tooling, with a variable section thickness profile. Rockport designed the bass driver from the ground up for the Avior II and Atria II. It has a vented titanium voice coil former, a cast aluminium frame, an oversized spider and a low-distortion motor system. Rockport's latest-generation midrange driver adds a low-loss roll surround and copper shorting rings in the motor, and the company quotes -60 dB second and third harmonic distortion for it.
Each crossover network is point-to-point wired to avoid the parasitic effects of PC-board construction. It uses custom film/foil capacitors manufactured exclusively for Rockport, custom inductors and Caddock power resistors, all matched to within 1% tolerance. Every network is fine-tuned with the exact loudspeaker it will be used with through select-on-test nodes, then encapsulated in a proprietary damping epoxy to minimise magnetostrictive and microphonic effects.
The triple-laminated, constrained mode damped enclosure has a solid 152 mm thick front baffle, curved side panels of variable section thickness and a crowned top surface. Large chamfers and constantly changing baffle dimensions reduce diffraction anomalies. The cabinet has a raked-back form and a high-gloss piano black finish.
Pairing
An amplifier stable into 4 ohms is required. Its output must exceed Rockport's minimum power figure.
Alternatives
The Atria II is another Rockport floorstanding loudspeaker and uses the same bass driver.