Hifiverse

Standlautsprecher - Bose 901 Series VI speaker system v2

Beschreibung, Bilder, technische Daten und Spezifikationen

Bose 901 Series VI speaker system v2
Bildquelle - (c) Bose

The 901 Series VI is the final generation of the Bose 901 Direct/Reflecting speaker, produced from 1987 until 2016. It is a passive system sold as a pair of speakers with a dedicated active equalizer, and each wide, low cabinet relies mainly on reflected rather than direct sound, which is the principle behind the Direct/Reflecting name.

Key specs that matter

Every cabinet holds nine 4.5-inch (11.4 cm) full-range drivers with Helical Voice Coils and no separate tweeter or woofer. Bose specifies that 89% of the energy leaves by reflection and 11% by direct radiation. Nominal impedance is 8 ohms, the speaker is compatible with amplifiers and receivers rated from 10 to 450 watts RMS, and the IEC rating is 250 watts. Each enclosure is 53.3 cm wide, 32.0 cm high and 33.0 cm deep, with a weight of 16 kg. Finishes were an oil-rubbed hardwood veneer with walnut finish or a black vinyl veneer.

Engineering and use context

Inside each cabinet, the 14-element Acoustic Matrix enclosure works with three reactive air columns. A series-connected 3 A quick-acting fuse protects the drivers. The system is meant to work with the 901 Series VI Active Equalizer, a line-level box in a black anodized aluminium case measuring 33.0 x 7.0 x 12.7 cm and weighing 1.5 kg. It has a 47 kohm input and a 1 kohm output, a usable dynamic range of 106 dB at 35 Hz, noise more than 90 dB below 1 volt and distortion under 0.09% THD at 1 kHz with a 1 V input. Its front carries a mid-bass control with a range of 6 dB up or down at 225 Hz, a mid-treble adjustment spanning the same 6 dB either way at 3 kHz and a bass switch giving a 6 dB cut at 35 Hz. The equalizer draws 3.5 W from the mains and came in 100 V, 120 V and 220-240 V versions. Bose also offered the PS-6 floor pedestals, which lift each cabinet off the floor.

Pairing

Because the equalizer works at line level, it goes into a tape monitor loop or in the link from a separate preamp to its power amp, so the amplifier or receiver needs one of those connections. The 8 ohm load and broad power window suit most transistor receivers and integrated amplifiers. Speaker cable runs should respect the gauge limits Bose sets - 18 AWG up to about 9 m, 16 AWG up to about 14 m and 14 AWG up to about 21 m.

Alternatives

The Bose 701 Series II is a floorstanding Direct/Reflecting design that stands upright without a pedestal and splits the range between a woofer, a midrange and two tweeters.

Spezifikationen

  • Modellbezeichnung

    901 Series VI speaker system v2

  • Untere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Obere Grenzfrequenz +/- 3dB (Hz)

    N/A

  • Empfindlichkeit (dB at 1 W/1m)

    N/A

  • Impedanz (Ohms)

    8

  • Anforderungen an den Endverstärker (W)

    10 - 450

  • Verfügt über interne Verstärkung

    k. A.

  • Leistung der internen Verstärkung (W)

    N/A

  • Größe (sm)

    53.3 x 32.0 x 33.0

  • Gewicht (kg)

    16.0

  • Offizieller Link