The SCM50ASL is the active version of the SCM50, a three-way standmount loudspeaker from ATC of England. ATC states that the SCM50 has been in continuous production since 1988 and that the speakers are hand-built in England. A passive sibling, the SCM50PSL, uses the same drive units, and both Classic models are supplied with speaker stands and fabric-wrapped grilles.
Key specs that matter
Drive units are a 234 mm (9 in) SB75-234SL bass driver (8 ohms), a 75 mm (3 in) SM75-150S mid-range dome (16 ohms) and a 25 mm (1 in) SH25-76S soft-dome tweeter (6 ohms). Low- and high-frequency cut-offs are 38 Hz and 25 kHz (-6 dB). Crossover points are 380 Hz and 3.5 kHz. Amplifier power is 200 W bass (8 ohms), 100 W mid (16 ohms) and 50 W HF (8 ohms). Maximum SPL is 112 dB. THD+N is below 0.0011% (1 kHz, 1 dB below rated power). Each speaker measures 716 x 304 x 480 mm (H x W x D), or 969 mm high on its stand, and weighs 47.05 kg.
Engineering and use context
ATC loads its 'SL' bass driver in a 50-litre vented cabinet, which is heavily braced and damped to suppress panel resonances. Above it sits the ATC Super Dome mid-range, and the tweeter is an ATC 'S-Spec' soft-dome dual-suspension HF driver.
Inside the cabinet is an on-board ATC active 350 W amp pack module with three class A/B MOSFET amplifiers, one per band. Its electronic crossover uses 4th-order Linkwitz-Riley filters behind a balanced input. Protection covers DC offset and over-temperature, both shown by a rear-panel LED, and an ATC active FET momentary gain reduction limiter is built in.
On the rear panel there is one balanced XLR input (pin 2 hot) with 20 kohm differential impedance and an input sensitivity of 1 Vrms for full power. DIP switches set the input sensitivity to 0, -3, -6 or -9 dB and a bass shelf to 0, +1, +2 or +3 dB. Mains voltage is 220-230 V or 115 V, factory set, and power consumption is 34 W at idle and 345 W at full power. Finishes include Black Ash, Cherry, European Walnut, Oak, Pippy Oak, Rosewood, Walnut, Satin Black, Satin White, Piano Black and Piano White, and the warranty is six years.
Pairing
A preamplifier or source with a balanced XLR output is required. A mains connection is required for each speaker.
Alternatives
The SCM100ASL is a larger active three-way loudspeaker in the ATC Classic range.