The SCM100ASL Pro is a three-way active studio monitor from ATC (Acoustic Transducer Company), founded in London in 1974 by Billy Woodman and based today at Aston Down in Gloucestershire. In ATC's suffix system SL denotes Super Linear Magnet technology and A denotes built-in amplification. It is used as a main or midfield monitor in larger control rooms and sits between the SCM50ASL Pro and the SCM150ASL Pro.
Key specs that matter
Driver complement is a 25 mm S-Spec dual-suspension tweeter, a 75 mm Super Dome midrange and a 314 mm full-specification SL bass driver. Each driver has its own amplifier in a grounded source tri-amp pack of 350 W total - 200 W LF, 100 W MF and 50 W HF continuous. Amplitude linearity is ±2 dB from 65 Hz to 17 kHz, and the cut-off frequencies are 32 Hz and 25 kHz (-6 dB, free standing). Maximum continuous SPL is 115 dB at 1 m. Dispersion is ±80° horizontal and ±10° vertical, coherent in both planes. Dimensions are 832 x 398 x 581 mm (H x W x D), and weight is 55.2 kg.
Engineering and use context
Crossover points are 380 Hz and 3.5 kHz, 4th order, critically damped with phase compensation. According to ATC, frequency, gain and phase correction of every amplifier pack is individually optimised at the factory, and pairs are matched to ±0.5 dB. ATC credits Super Linear technology and underhung voice coil construction for low distortion at all levels. Its cabinet is ported.
Overload protection is active peak momentary gain reduction on all channels, plus an r.m.s. power limiter on the HF channel. Two indicators sit on the front panel - power on and a gain reduction warning. On the rear panel a screwdriver trim sets input sensitivity from 0 to -6 dB, and a bass boost adds 0 to +6 dB around 40 Hz, both continuously variable. ATC notes that turning either control without the ability to recalibrate puts the two speakers of a pair out of calibration. Standard veneers are Black Ash, Mahogany, Cherry and Natural Oak, with others to special order. Returning the warranty card extends the warranty to six years.
Pairing
The input is a female XLR, balanced, with 10 kohm per leg and a sensitivity of 1 V rms (0 dBV/1.1 dBu) for full output. A console, monitor controller or preamplifier with balanced line outputs is required. No external power amplifier is needed.
Alternatives
The ATC SCM150ASL Pro uses the same tri-amp pack and crossover points with a 375 mm bass driver and a 117 dB maximum continuous SPL.