The prodigy1 is the compact standmount model of PMC's prodigy range, which also includes the floorstanding prodigy5. PMC designs and builds the range in-house in Britain and describes the prodigy1 as closely related to its compact nearfield monitors, used in recording and broadcast facilities. Despite the small cabinet it contains a full-size Advanced Transmission Line with a Laminair vent. Finish is Silk Black, and magnetically attached grilles are optional.
Key specs that matter
The prodigy1 is a two-way design with a PMC 133 mm (5.25 in) natural fibre long-throw LT bass unit and a PMC 27 mm (1 in) soft-dome tweeter, crossed over at 1.7 kHz. Frequency response is 50 Hz - 25 kHz (-3 dB). Sensitivity is 87.5 dB SPL (1 W/1 m) and impedance is 6 ohms. Recommended amplifier power is 20 - 250 W, and peak SPL is 123 dB. The effective ATL length is 1.91 m. Horizontal and vertical directivity are both 80 degrees. Each cabinet measures 320 x 162 x 237 mm (H x W x D), plus 20 mm for spikes and 10 mm for the optional grille, and weighs 4.5 kg.
Engineering and use context
In the ATL bass loading the highly braced cabinet is lined with proprietary acoustic materials that absorb all but the very lowest frequencies. These exit from a front vent and extend the low-frequency response. PMC states that the bass extension does not change with volume level. At the vent exit, the Laminair aerodynamic vent applies F1 aerodynamic principles to reduce resistance and airflow noise.
Like all PMC bass drivers, the LF unit is optimised for use with the ATL. It has a natural fibre dished diaphragm with an inverted dust-cap, which reduces high-frequency reflections from the driver surface. A high-power voice coil and ferrite magnet are combined with a long excursion suspension, and generous venting is used for reliability. Its drivers and crossover design are also found in PMC studio speakers. The soft-dome tweeter is derived from the result6 studio nearfield monitor and is also used in PMC's custom installation range.
Pairing
The single pair of 4 mm binding posts accepts spade lugs, banana plugs and bare wire and does not allow bi-wiring. Other PMC speakers can be combined with the prodigy1 in surround systems.
Alternatives
The prophecy1 is another standmount loudspeaker from PMC's domestic range.