The Orfeo is a two-way compact loudspeaker from Odeon Audio, a German maker whose loudspeakers are hand-built in Germany. It has been in the Odeon range for 20 years, and Odeon counts more than a thousand customers for its various versions. In 2024 it was relaunched with a new cabinet design, new dimensions and, for the first time, a built-in wooden bass reflex tunnel. Finishes are poplar, oak, walnut and walnut root.
Key specs that matter
It is a two-way bass reflex design with a 25 mm dome tweeter in a birch plywood horn and a single low-midrange driver, crossed over at 2.2 kHz. Frequency range is 40 Hz - 21 kHz. Sensitivity is 90 dB with an 8 ohm impedance. Dimensions are 41 x 22 x 32.5 cm (H x W x D).
Engineering and use context
Audax of France makes the tweeter as a special design for Odeon. Its 25 mm dome is of specially impregnated fabric and carries a copper voice coil. In front of it sits Odeon's own 17 cm horn of birch plywood, which according to Odeon functions as a mechanical amplifier that relieves the tweeter.
Scan-Speak of Denmark builds the low-midrange driver, also as a custom unit outside normal production. It combines a hand-made, coated cellulose cone with a fine, flexible rubber surround and a fabric centering spider.
Cabinet panels are MDF with a high proportion of wood fibres and binding agents, compressed under high pressure. Odeon states that this MDF is up to 1.8 times heavier than conventional MDF. The 2024 cabinet has new proportions and a wooden reflex tunnel inside the enclosure, and the placement and design of the reflex channel were changed from the previous versions.
Each crossover uses selected parts with a maximum deviation of 1% to keep the two channels close, film capacitors only and Mundorf coils. Instead of a Pertinax board with conductor tracks, it is wired by hand, soldered point to point and then mechanically secured. Both terminals sit on acrylic plates that also carry the complete crossover, so terminals and crossover are connected directly, and large metal carrier parts are deliberately avoided. Internal cabling is oxygen-free copper (OFC) from German production, with multiple mechanical shielding on the high-frequency cable.
Pairing
An amplifier rated into 8 ohms is required. Tube and solid-state amplifiers are both suitable.
Alternatives
Every other model in the current Odeon Audio range is a floorstanding loudspeaker, so the Orfeo has no stand-mount alternative from the brand.