The Q Acoustics Concept 30 is a mid-size bookshelf speaker in the Concept series, the range-topping line of the London-based brand. It was launched together with the Concept 50 floorstanding speaker and the Concept 90 centre speaker. Concept 30 keeps the aluminium front baffle plate of the original Concept models and the design lines of the Concept 300 and Concept 500, and it comes in black or white high-gloss lacquer.
Key specs that matter
Design is two-way with bi-wire terminals. Drive units are a 125 mm (5.0 in) bass unit and a 25 mm (1.0 in) treble unit, crossed over at 2.4 kHz. Frequency response is 54 Hz - 30 kHz (-6 dB). Sensitivity is 87 dB (2.83 V at 1 kHz). Nominal impedance is 6 ohms, minimum impedance 3.9 ohms. Recommended amplifier power is 25 - 100 W. Effective volume is 7.0 litres. Dimensions are 284 x 180 x 319 mm (H x W x D), and weight is 7.9 kg per speaker.
Engineering and use context
Both drive units are new designs made for the Concept 30, 50 and 90. Its mid/bass driver has a 30.5 mm voice coil, and Q Acoustics quotes a 50% increase in power handling over a comparable driver with a 25.4 mm coil. Each driver is fixed to a 3 mm aluminium baffle plate, which is mounted to the cabinet front by pretensioned studs to give the acoustic seal and limit structural coupling. The tweeter is hermetically sealed and mechanically isolated (floating) from the baffle, shielded from internal resonances of the mid/bass unit.
Gelcore construction, introduced in the original Concept, places a non-setting gel between two layers of cabinet wall. This gel converts high-frequency vibration from the moving drivers into heat. P2P (Point to Point) internal bracing, first used in the Concept 500, was positioned with Finite Element Analysis and laser interferometry and is applied only at the points of the cabinet that need stiffening against low-frequency vibration.
Under the cabinet sits a sprung isolation base, a variation of the Concept 300 design, with two plates separated by suspension spheres that isolate the speaker from external vibration. The crossover is mounted on this base, away from the electromagnetic fields of the drive units, to minimise microphonic pick-up. Grilles and foam bungs are included.
Pairing
An amplifier stable into 4 ohms is required. Its bi-wire terminals allow separate cable runs to the bass and treble sections. The matching stand is the Q Acoustics FS75.
Alternatives
The Q Acoustics Concept 300 is the larger bookshelf model of the Concept series.