The S17 Pro EVO is a fully-discrete, class-A, fully-balanced headphone amplifier from Aune Audio of China, and it also works as a preamplifier. It is the updated S17 Pro. Aune lists 657 components against 635 in the earlier model, and the EVO adds independent switching between headphone and preamp output mode, a separately stored volume for each mode and an automatic screen-off option. The price is USD 799, against USD 699 for the S17 Pro.
Key specs that matter
At high gain the balanced output gives 7500 mW into 32 ohms, 2673 mW into 100 ohms, 918 mW into 300 ohms and 459 mW into 600 ohms. On the 6.35 mm single-ended output the figures are 2050 mW into 32 ohms, 235 mW into 300 ohms and 117 mW into 600 ohms. Frequency response is 20 Hz - 80 kHz (±0.05 dB). THD+N is below 0.00016% (1 kHz) on XLR and below 0.0003% on 6.35 mm, with SNR above 116 dB and 115 dB (600 ohms) and crosstalk below -110 dB and -105 dB (1 kHz, 600 ohms). Headphone output impedance is 1 ohm. Input impedance is 10 kohms on RCA and XLR, and the preamp outputs are 200 ohms (RCA) and 100 ohms (XLR). Operation stays fully in class A above 77.8 ohms single-ended and 155.6 ohms balanced. Dimensions are 288 x 211 x 63 mm.
Engineering and use context
A twin JFET sits at the input. In the final output stage two pairs of output transistors are connected in parallel per channel, 16 output transistors in all. Quiescent current has two levels, A-L and A-H, of 50 or 100 mA per transistor and 100 or 200 mA per channel. At 69 °C the amplifier switches automatically to A-L. Volume is a 4-way balanced R2R control on a JRC electronic volume chip with dedicated op-amps, in 63 steps.
Power comes from a 50 W low-ripple toroidal transformer and a 19200 µF capacitor array, with digital control and analogue sections supplied separately. Its heat sinks, a bottom heat plate and the chassis form one cooler, vented through the rear plate. Headphone outputs are 6.35 mm, 4.4 mm balanced and 4-pin XLR, next to RCA and XLR inputs and preamp outputs. A 4-inch display shows input, gain, volume, quiescent current, power transistor temperature and output mode. Included are an all-aluminium remote, a power cord and a 6.35 to 3.5 mm adapter.
Pairing
Aune's matching sources are the S10N and S10 Pro players. The recommended headphones are the Aune SR7000. Only one pair of headphones should be connected at a time. The preamp outputs drive a power amplifier or active speakers.
Alternatives
The Aune S17 Pro is the earlier version with the same twin JFET class A circuit, without independent output switching and mode memory.