The PB6 Macaw is a portable, fully balanced headphone amplifier from iBasso with two output modes, a tube mode and a solid-state Class AB mode. It has no DAC, so the source must provide an analogue signal at its 3.5 mm or 4.4 mm input. Power comes from the internal battery or from an external 12 V DC supply. iBasso lists it at USD 399.
Key specs that matter
Output power from the 4.4 mm balanced output is 2300 mW + 2300 mW into 32 ohms with DC 12 V and 1600 mW + 1600 mW on battery (THD <1%), with 9.5 Vrms and 8.5 Vrms maximum output level. From the 3.5 mm single-ended output it is 660 mW + 660 mW into 32 ohms on either supply. Output impedance is 1.2 ohms balanced and 0.5 ohms single-ended. In Class AB mode the balanced path measures -112 dB THD+N (2 V input, 300-ohm load), 125 dB dynamic range, 135 dB crosstalk and a 2.3 µV noise floor, with 10 Hz - 80 kHz (-0.1 dB) response. Tube mode gives 15 Hz - 80 kHz (-0.5 dB), 116 dB dynamic range and 100 dB crosstalk. Balanced gain is +6 or +12 dB in Class AB mode and +8 or +14 dB in tube mode. Size is 140.7 x 78.9 x 19.6 mm, and weight is 293 g.
Engineering and use context
Four military-grade JAN6418 directly heated pentodes made by Raytheon form a 4-channel fully balanced amplification architecture, and iBasso tests and matches them on an APX555 analyser. In tube mode they are the amplification cores, with an anode power supply of 22.5 V. Class AB mode uses an OP+BUF headphone amplifier circuit with four BUF634A for current amplification. All four tubes are suspended in PORON damping material against microphonics, under a metal mesh shielding cover against electromagnetic interference.
Instead of a single 3.7 V cell, the PB6 uses an 8.4 V polymer battery pack. According to iBasso, this pack reduces ripple from DC-DC conversion. With the 12 V DC supply the voltage swing is 24 V. Average play time is 13.5 hours in Class AB mode and 9.5 hours in tube mode, and charging takes 2.5 hours. Volume is set by an NJW1195A 4-channel volume control IC in 0.5 dB steps. On the rear panel are the DC 12V and USB-C charge sockets and switches for GAIN, BW (high or low bandwidth of the output stage) and MODE.
Pairing
Inputs are 3.5 mm single-ended and 4.4 mm balanced. A 3.5 mm input into the 4.4 mm output adds a further 6 dB of gain. The box includes a 12 V power adapter, a USB-C cable and short 3.5 mm and 4.4 mm interconnects.
Alternatives
The iBasso PB5 Osprey is an earlier portable balanced headphone amplifier from iBasso, with Nutube 6P1 tubes.