The Ovo Evolution is a tube headphone amplifier from Fezz Audio of Poland. Brothers Tomasz and Maciej Lachowski set the company up in 2015 near Bialystok as an offshoot of Toroidy, the toroidal transformer maker their father Lech Lachowski founded in 1992. Fezz describes the Ovo as an amplifier developed to drive any headphone, including the most difficult ones. It belongs to the Evolution series, a redesign of the Fezz range carried out with the Warsaw design studio Kabo and Pydo. The Ovo was presented in September 2025 at about EUR 3,495, and the Polish list price is PLN 14,900.
Key specs that matter
Circuit type is class A single-ended triode (SET). Tube complement is one 12AX7 and two EL84, with automatic bias. Maximum output power is 1500 mW (THD = 2%), and THD is below 1% at 1000 mW. Frequency response is 16 Hz - 120 kHz (-3 dB, Z = 32 ohms). Recommended headphone impedance is 16 - 600 ohms in three ranges (LOW, MID, HIGH). Input sensitivity is 850 mV. Signal inputs are 1 x RCA and 1 x XLR, and signal outputs are 1 x RCA and 1 x XLR. Power consumption is 40 W. Dimensions are 355 x 380 x 100 mm, and weight is 10.5 kg.
Engineering and use context
Both the power transformer and the output transformers are made by Toroidy. Three headphone sockets are on the front panel - an XLR balanced socket, a 4.4 mm Pentaconn balanced socket and a 6.35 mm jack - next to the volume potentiometer, the impedance selector, the source selector and an IR remote sensor. On the rear panel are an extension slot, a signal ground switch and a mains voltage selector for 115-120 V or 230-240 V at 50-60 Hz.
Fezz specifies the LOW position for 32 ohm headphones, MID for up to 150 ohms and HIGH for 150 ohms and above, and HIGH for planar magnetic headphones as well. With automatic bias, replacement tubes have to be pre-selected and matched. The tubes are accessed by sliding a plexiglass window on the top cover to the left. A remote control and a Bluetooth module for the extension slot are optional. Seven finishes are available - Big Calm, Black Ice, Burning Red, EverGreen, Moonlight, Republika and Sunlight.
Pairing
A line-level source with RCA or balanced XLR outputs is required, such as a DAC, streamer or CD player. A turntable requires an external MM/MC phono preamplifier or a built-in phono stage. The RCA and XLR outputs allow connection to a power amplifier or active speakers.
Alternatives
The Fezz Omega Lupi Evolution is the push-pull headphone amplifier of the range, with four PCL86 tubes in class AB1 and a 32 - 600 ohm load range.