The Linear D is a headphone amplifier and preamplifier from Lehmann Audio with a built-in digital-to-analogue converter. Its current mk II version has a converter of the latest generation and a thoroughly revised analogue board. Lehmann presents it as a complement to streamers and CD players and as a streaming preamp for active loudspeakers.
Key specs that matter
Output power is 400 mW into 60 ohms and 200 mW into 300 ohms. Maximum gain is selectable via DIP switches at 0, 10, 18 or 20 dB. Frequency response is 10 Hz (-0.3 dB) to 35 kHz (-1 dB), signal-to-noise ratio is above 100 dB at 0 dB gain, and THD is below 0.001% at 6 mW/300 ohms. Channel separation exceeds 80 dB at 10 kHz. Input impedance is 47 kohms, while output impedance is 5 ohms at the phones outputs and 50 ohms at the pre-out. Its DAC section uses the ESS Sabre K2M chipset at 24-bit resolution, accepts 32, 44.1, 48, 88.2, 96 and 192 kHz and has a maximum output level of 1.8 V. Power consumption is 15 W through an internal, regulated power supply. The housing measures 110 x 280 x 44 mm (W x D x H) and weighs 1.5 kg net.
Engineering and use context
Two headphone outputs run in parallel on the discrete class A solid-state output stages, and Lehmann specifies them for two headphones of equal impedance. Both are Neutrik headphone jacks with gold-plated contacts. Inputs comprise one analogue input, one Toslink input and one 75-ohm RCA coaxial input. With no input selector on board, the unit recognises a digital signal and selects the input automatically. Toslink is prioritised, and the analogue input is activated when no digital signal is recognised. All RCA sockets are gold-plated with Teflon insulation.
Inside, the Sabre DAC sits on a quad-layer circuit board optimised against RF interference, and silver mica capacitors are used in the analogue filter of the converter. Lehmann makes the analogue board in Low-Z Copper. Volume is set with a massive, damped potentiometer, and vibration-absorbing 3S Device Feet decouple the housing from its base.
Pairing
The pre-out connects to active loudspeakers or a power amplifier. Digital sources connect over Toslink or coaxial S/PDIF.
Alternatives
The Linear SE is Lehmann's larger headphone amplifier, with the same output power ratings in a 120 x 296 x 59 mm housing.