The KHV-200 is a hybrid headphone amplifier and line preamplifier in the tubeLine range of the German brand Vincent. It was developed with Dipl.-Ing. Frank Blöhbaum, who was also in charge of the SV-237MK, SV-737 and SA-T7. In 2021 the price was EUR 999, and the fascia is black or silver.
Key specs that matter
Frequency response is 20 Hz - 20 kHz (±0.1 dB). THD is below 0.01% (1 kHz, 0.1 W, 32 ohms), and the signal-to-noise ratio is above 95 dB. Input impedance is 33 kohms, with a maximum input voltage of 4 V RMS. Nominal gain at the headphone output is -2.66 dB (low gain) or 13.64 dB (high gain). At the pre out it is -11.06 dB or 5.13 dB, and the record output is 0 dB. Connections are two stereo RCA inputs, RCA pre out and rec out pairs and two headphone sockets. Its tube complement is two E180F/6SCH9P and one ECC82. Mains voltage is switchable between 230 V/50 Hz and 115 V/50/60 Hz. Dimensions are 210 x 85 x 277 mm (W x H x D), and weight is 3.6 kg.
Engineering and use context
Vincent notes that the impedance of high-quality headphones ranges from 16 to 600 ohms. A low-impedance model needs more current at a lower voltage, while a 300 or 600 ohm model needs a comparatively high voltage at a lower current. The KHV-200 was designed to drive almost all of them, with the integrated gain switch as the adjustment. According to the manual, this hybrid circuit combines tubes with transistor amplification. Activating GAIN reduces the output signal by 8 dB, intended for headphones that are already loud at low volume settings.
On the front panel sit the balance control, the warm-up and power LED, the power switch, a tube window, the CD/AUX input selector, the volume dial and a 6.3 mm headphone socket. A 4-pin XLR headphone socket is on the rear, and both headphone outputs are specified for loads of at least 32 ohms. One volume dial sets the headphone level and the pre out signal. REC OUT carries the selected source independent of volume, balance and gain. A three-step dimmer sets the tube window light, and 3.5 mm power control jacks take a 12 V trigger signal. When switched off, the unit is separated from the mains and has no standby state.
Pairing
Line-level sources with RCA outputs are required. The pre out connects to a stereo power amplifier or two mono power amplifiers. Headphones with an impedance of 32 ohms or more are specified.
Alternatives
The Vincent KHV-1 is the brand's earlier hybrid preamplifier and headphone amplifier.