The HPA V101 is a headphone amplifier from Violectric, the hi-fi brand of the German company Lake People Electronic, and the entry model of its headphone amplifier range. Violectric describes it as a transistor amplifier based on Lake People and Violectric technology. Other headphone amplifiers in the current Violectric range are the HPA V222, HPA V550 and DHA V226.
Key specs that matter
Inputs are one balanced XLR (Neutrik) and one unbalanced RCA, selected with a switch on the rear panel. Input impedance is 10 kohms, maximum input level is +21 dBu and nominal input sensitivity is +6 dBu. Pre-Gain is switchable in seven 6 dB steps (-18 / -12 / -6 / 0 / +6 / +12 / +18 dBr). Headphone outputs are two unbalanced 6.3 mm jacks. Output power (both channels loaded) is 770 mW into 16 ohms, 1400 mW into 32 ohms, 2050 mW into 50 ohms, 1750 mW into 100 ohms, 1050 mW into 300 ohms and 600 mW into 600 ohms, with 18.9 V RMS available into 600 ohms. Frequency response is 5 Hz - 250 kHz (-0.5 dB), output impedance is 0.125 ohms and damping factor into 50 ohms is 400. Dynamic range is above 129 dB (A-weighted), noise is below -101 dBu (A-weighted) and THD+N is below 0.001% (1 kHz, 2 x 10 V into 100 ohms). Crosstalk is -110 dB at 1 kHz and -95 dB at 15 kHz. The case measures 170 x 49 x 165 mm (W x H x D), or 170 x 57 x 197 mm overall.
Engineering and use context
According to Violectric, the internal operating voltage is 50 V, and a very small internal gain keeps the self-noise of the amplifier inaudible. The selected input is buffered, passes through the seven-step Pre-Gain and then reaches the Alps RK27 volume potentiometer before the output stages. Gain of the output stage is +6 dB. Its 25 mm knob is machined from solid aluminium. The headphone outputs are connected with a delay after power-on and disconnected immediately at power-off. Power comes from a built-in supply with a 10 W toroidal transformer, and maximum consumption is 10 VA at 230 V or 115 V AC. Front, rear panel and case are black anodised aluminium.
Pairing
A line source with a balanced XLR or an RCA output is required. Pre-Gain is set to match the output level of the source and the sensitivity of the headphones. Headphones with a 6.3 mm single-ended plug connect directly, and two pairs can be used at the same time.
Alternatives
The HPA V222 is the Violectric headphone amplifier with a fully balanced output stage built from four amplifier circuits.