Hifiverse

Sonstige Geräte - Phasemation T-600

Beschreibung, Bilder, technische Daten und Spezifikationen

Phasemation T-600
Bildquelle - (c) Phasemation

The Phasemation T-600 is a passive MC step-up transformer from the Yokohama maker of cartridges, phono amplifiers and tube electronics. It lifts the small signal of a moving-coil cartridge up to the level that a standard MM phono input is designed for, using transformer windings instead of an active gain circuit. Phasemation developed it as a reworked successor to the T-550, which had been the mid-priced bestseller among its step-up models, and it sits between the T-550 and T-1000 in a family of five transformers from the T-320 up to the T-2000.

Key specs that matter

The voltage gain is a fixed 26 dB, and Phasemation matches the unit to cartridges with an output impedance between 1.5 and 40 ohm, working into a load of 47 kohm. Frequency response runs from 10 Hz to 100 kHz within 2 dB. Inputs and outputs each come in two forms, a balanced XLR pair and an unbalanced RCA pair, the XLR sockets made by Neutrik and the RCA jacks gold-plated. The compact box is 174 mm wide, 93 mm high and 188 mm deep, with a weight of 2.1 kg.

Engineering and use context

Phasemation prefers transformer step-up over electronic head amps because a transformer gives ideal impedance matching and, having no power supply, contains no source of noise. For the T-600 the company revised the production of the transformer itself, with more precise control of wire tension during winding. Inside the housing a shield plate limits leakage flux, and the transformer rests on damping rubber in a floating mount to keep vibration away from them. A rotary switch with gold-plated contacts selects BALANCE, UNBALANCE or PASS, and the internal wiring is kept as short as possible. Input selection is new compared with the T-550, which could not switch between balanced and unbalanced sources. The PASS position routes the signal around the transformer, so an MM cartridge or a high-output MC that needs no step-up can stay connected and be used without rewiring, even when the tonearm cable is balanced. The added XLR output allows connection to phono amplifiers that accept only balanced input.

Pairing

The T-600 belongs between a turntable fitted with a low-output, low-impedance MC cartridge and the MM input of an integrated amplifier or phono stage. It is most useful where the amplifier has a single phono input, since PASS mode lets an MM cartridge share that input without swapping cables. Owners of balanced phono stages can run the whole chain from tonearm to phono amplifier over XLR.

Alternatives

The Phasemation T-1000 is the next step-up transformer in the range, built as a pair of separate mono chassis with Furutech rhodium-plated terminals.

Spezifikationen

  • Modellbezeichnung

    T-600

  • Highlights

    Adapted cartridge impedance 1.5 - 40 ohms, Recommended load impedance 47kΩ, Step-up ratio 26dB, Frequency response 10 - 100k Hz (±2dB)

  • Abmessungen (mm)

    174 x 93 x 188

  • Gewicht (g)

    2100

  • Offizieller Link