Hifiverse

Sonstige Geräte - T+A PS 3100 HV

Beschreibung, Bilder, technische Daten und Spezifikationen

T+A PS 3100 HV
Bildquelle - (c) T+A

The PS 3100 HV is an external power supply from T+A of Herford, Germany, for the A 3100 HV power amplifier and the PA 3100 HV integrated amplifier of the HV series. Once it is connected, the amplifier's internal power supply is dedicated to the input stages and high-voltage amplifiers only, and the PS 3100 HV alone supplies the output stages. It was announced in September 2026 at EUR 13,900 and USD 19,490.

Key specs that matter

Transformer rating is 1200 VA. Reservoir capacity is 240,000 µF, double the filter capacitance of the amplifiers themselves. Up to 1200 joules of stored energy are available to the output stages. Mains supply is 110-120 V/60 Hz or 220-240 V/50 Hz, with a rated consumption of 1800 W and standby consumption below 0.5 W. Dimensions are 170 x 460 x 460 mm (H x W x D), and weight is 38 kg. The case is finished in silver lacquer or titanium lacquer with a black ventilation grille cover.

Engineering and use context

T+A connects the supply to the amplifier with the M-23 Special Powerlink cable, which has M-23 high-current connectors. With the output stages on their own supply, the input and voltage gain stage of the amplifier is fully isolated from them. Its capacitor bank consists of 24 custom-developed capacitors wired in parallel. According to T+A, this parallel configuration brings internal resistance and inductance down to a minimum.

A processor-controlled soft start limits the initial current draw, ramps up the system voltages and charges the capacitors gently, so switching on does not trip the domestic fuses. If the soft start detects a fault, the LED flashes red. Power-on and power-off are controlled automatically by the connected amplifier. A safety power-off circuit cuts the voltage at the contacts when the Powerlink cable is disconnected. In the High current mode of the A 3100 HV the PS 3100 HV stays inactive.

For the PS 3100 HV the large-format VU meter of the HV series was re-engineered to match the A 3100 HV. Working as a mains monitor, it displays the operating voltage, the current drain to the output stages or the level of interference on the mains. Its display mode is selected from the A 3100 HV, the P 3100 HV preamplifier or the PA 3100 HV. On the rear panel are the POWER LINK OUT socket, an H LINK control input and the mains input. The supplied Powerlink cable is intended for stacked installation, and a long cable is available for side-by-side placement.

Pairing

Only an A 3x00 HV power amplifier or a PA 3x00 HV integrated amplifier may be connected to it. A mono system uses two A 3100 HV with two PS 3100 HV.

Alternatives

The PS 3000 HV is the earlier T+A external power supply of the HV series.

Spezifikationen