The LIVEBOX is a fully integrated one-box stereo system developed jointly by Weiss Engineering, PSI Audio and Illusonic of Switzerland and sold by Weiss Engineering as the ONE-BOX Stereo System. One enclosure holds the input and streaming stage, the digital signal processing, the D/A conversion, the amplifiers and the drivers of an active three-way stereo loudspeaker.
Key specs that matter
Digital inputs are AES/EBU or S/PDIF via XLR, two Toslink and RCA sockets, plus USB. Analogue inputs are on XLR and RCA. Network playback covers UPnP/DLNA, Roon Ready and Qobuz Connect. Accepted formats are PCM 44.1 kHz up to 384 kHz and DSD 64x/128x. Two stereo AES/EBU outputs on XLR and a stereo analogue output on XLR and RCA connect subwoofers, preamplifiers, active speakers or headphone amplifiers. The enclosure measures 1,500 x 435 x 220 mm (L x W x H), and power comes through an IEC mains connector with automatic mains voltage detection.
Engineering and use context
Midrange drivers sit at the outer ends of the cabinet, while the tweeters are close to the bass drivers near the centre. A port spans the entire bottom surface, with openings to the front and rear. PSI Audio hand-makes the HDF cabinets in Switzerland.
All audio processing runs on two ADSP-21488 SHARC DSPs. The second one runs the Crosstalk Canceling (XTC) algorithm developed with Illusonic, a multiband process with linear-phase filters that adds the original stereo signal to keep the overall frequency response flat. As a concept it was presented at the 2016 AES Convention in Paris and published in 2017 in the AES paper Linear Phase Crosstalk Cancellation Filters. The Speaker-Listener Distance is adjustable in the user interface. An AM335x ARM processor runs the Master Control Engine and the streaming renderer.
Weiss Engineering supplies the D/A stage, an ES9038PRO chip with eight channels, six for the drivers and two for the analogue outputs, followed by a fully balanced analogue stage with locally regulated supplies. Output level is set in four analogue steps plus continuous digital volume control. Class A/B amplifiers from PSI Audio drive the neodymium tweeters, and class G/H amplifiers drive the bass and midrange units without heat sinks. Every driver has PSI Adaptive Output Impedance (AOI), a motion feedback system, and each one is measured in the PSI Audio anechoic room in Yverdon-les-Bains. Control is by infrared remote, web browser and a gesture sensor, and a 4-digit dot-matrix display shows volume, mute and input.
Pairing
No external amplifier or loudspeakers are required. A subwoofer, active speakers or a headphone amplifier connect to the stereo analogue output.
Alternatives
There is no other one-box system in the LIVEBOX range.