The A810 is a professional reel-to-reel tape recorder for 6.3 mm tape from the Swiss company Studer, built during the 1980s for broadcast and studio use. Studer produced it in mono, stereo, two-channel and two-channel time code versions. Each version was available as a rack-mount chassis, a console on castors, a box-mounted unit or a portable case with handles. Early machines have a 4-digit LCD tape counter, which Studer later replaced with a 5-digit LED display.
Key specs that matter
Reels up to 282 mm in diameter with NAB, CINE (EIA) or DIN hubs are accepted. LS versions run at 9.5, 19 and 38 cm/s, and HS versions add 76 cm/s, selected with a rotary switch on the front panel. Varispeed range is ±7 semitones. Frequency response (±2 dB) is 40 Hz - 22 kHz at 76 cm/s, 20 Hz - 20 kHz at 38 cm/s, 20 Hz - 16 kHz at 19 cm/s and 20 Hz - 10 kHz at 9.5 cm/s. Signal-to-noise ratio (NAB, A-weighted) is 74, 70, 72 and 61 dB at those speeds, and maximum wow and flutter is 0.04% at 76 cm/s and 0.12% at 9.5 cm/s. The portable model measures 483 x 500 x 237 mm (W x H x D) without reels and weighs 31 kg net. On castors, the console is 1,152 mm high.
Engineering and use context
Tape transport and head assemblies are mounted on a die-cast aluminium alloy chassis, and the deck operates in any position from horizontal to vertical. A microprocessor controls the machine. Its capstan motor has a quartz-controlled servo with a capacitive tachometer, tape tension is regulated electronically by non-contacting sensors, and the spooling motors are driven by pulse-width modulation. Equalisation is switchable between NAB and CCIR at 19 and 38 cm/s, and a bias switch covers two tape formulations. After power-off the A810 keeps its last operating state, including the counter reading, locator addresses, speed and equalisation.
For editing there are a zero locator and four programmable locator addresses, with an optional tape marker and built-in scissors. Options include SMPTE time code for the two-channel models (not usable at 9.5 cm/s), a test generator at 60 Hz, 125 Hz, 1 kHz, 10 kHz and 16 kHz, and a remote controller with an RS-232 serial interface.
Pairing
Inputs and outputs are balanced and floating, with optional transformers, for connection to professional preamplifiers and mixing desks. A VU meter panel can be switched internally to PPM readings, and a monitor speaker is built into the transport cover. Mains voltage is selectable from 100 to 240 V at 50 or 60 Hz.
Alternatives
The Studer A820 is a higher-tier professional reel-to-reel tape recorder from the same maker.