The Statement NAC S1 is the preamplifier of the Statement series from Naim Audio of Salisbury, England, a two-model range completed by the NAP S1 mono power amplifiers. According to Naim, Steve Sells, its Electronic Design Director, first conceived the idea over a decade before launch, and development began in earnest in 2011. Naim first showed the pair at CES Las Vegas on 7 January 2014, with shipping from July 2014. The UK price was GBP 57,000 at launch and now stands at GBP 74,999.
Key specs that matter
Analogue inputs are 3 x DIN, 3 x RCA and 2 x balanced XLR. Outputs are 1 x balanced XLR and 2 x unbalanced on 4-pin DIN sockets. Analogue gain is 15 dB + 30 dB. Mains power supply is 115 V or 230 V, 50/60 Hz, and a Power-Line mains cable is supplied. Dimensions are 940 x 270 x 412 mm (H x W x D), with the width including the stabiliser, and weight is 61.5 kg.
Engineering and use context
Naim mapped out the design using 3D computer models to confirm the best position for each component. The NAP S1 shares the same fundamental layout. Its power supply is at the bottom, the sensitive electronics are in the upper half, and an acrylic partition between them prevents interaction. Within the top section, internal chambers isolate individual stages.
At the input stages in the lower enclosure all switching is mounted on a brass frame, which is suspended on a leaf-spring system and covered by an inert metallic cage. Every input is individually isolated. The signal is converted to balanced in the lower half and then passes through the acrylic divide to the main analogue boards. These boards are suspended vertically within a brass sub-chassis with a resonant frequency of 12 Hz, a mass-loaded suspension first used in the Naim 500 Series. A board with Naim DR discrete regulators is suspended in parallel to the audio circuitry, giving each stage its own dedicated supply.
Volume is set by the Naim DVC (Dual Volume Control). A chip volume control operates while the level is changing and then switches out of circuit, leaving the stepped attenuator, which uses a fixed set of single resistors for each of its 100 volume steps. Key components are matched by hand, and wiring and assembly are carried out by hand in Salisbury.
Pairing
The matching power amplifiers are two NAP S1 monoblocks, each with one XLR input. Naim recommends Focal Grande Utopia EM Evo or Stella Utopia EM Evo loudspeakers with Statement.
Alternatives
The Naim NAC 552 is the brand's preamplifier for a system below the Statement.