The PR140 is a tube line preamplifier from Kora, designed and built in Toulouse, in the Occitania region of France. It is the control unit of the 140 series, alongside the CD140 player and the DAC140 converter, and it uses Kora's Square Tube operational amplifier with four triodes per channel. An extension slot at the rear accepts an optional DAC or phono drawer that the owner can install. The French price was EUR 5,880.
Key specs that matter
There are five line inputs, one balanced on XLR and four on RCA, all with the same sensitivity and an input impedance above 10 kohms. Outputs are on RCA and XLR sockets, with an output impedance below 50 ohms and a bandwidth of 20 Hz - 20 kHz. The DAC option adds two RCA coaxial and two Toslink optical inputs with 32-bit, 768 kHz conversion, and the phono option adds one MM/MC input on RCA. High voltages are +240 V and -240 V stabilised, and tube heating runs on 12 V DC. Chassis size is 100 x 420 x 340 mm (H x W x D), 118 x 420 x 355 mm overall, and weight is 7 kg. Its case is aluminium and steel in mineral grey.
Engineering and use context
Four double triodes form one Square Tube stage, and the name comes from the four tubes used in a single amplification stage. Kora describes the circuit as a differential stage followed by an output stage close to an OTL push-pull. In the preamplifier the tubes provide the gain and a pair of transistors assists them in driving the output cable. Output tube currents are fixed by reference voltages and kept much lower than their rated current, and the stage runs from two regulated high voltages, one positive and one negative.
Volume is adjustable from 00 to 80, and these numbers are position marks, not gain in dB. A mute key on the remote sets the level to 00 and restores it on a second press. Each input has its own gain offset, and balance covers ±10 graduations. At start-up the display shows the input, balance, volume and offset as they were at the previous standby. Start-up and switch-off are organised by a microcontroller, which also monitors the tube voltages.
To install an extension, the unit is switched off, the four screws of the slot cover are removed and the drawer is pushed in on its rails. At the next power-up the preamplifier recognises the module. On the phono drawer, MM or MC is chosen in the setup menu or with the Phono key, and MC impedance and capacitance are set with switches on the underside.
Pairing
A power amplifier with an XLR or RCA input is required. The matching power amplifiers are the Kora TA240 and TA480, and the matching sources are the CD140 and DAC140.
Alternatives
The PR140 is the only line preamplifier in the Kora range.