The Pilot Phono and Line Preamplifier is an all-tube stereo preamplifier from Pilot Radio, the American brand that Isidor Goldberg, a former test pilot, founded in Brooklyn in 1919. Pilot ran television broadcast tests in 1928 and became known for affordable hi-fi components in the 1950s and 1960s, and after Goldberg's death in 1961 it passed to Emerson Radio, which used the name until the mid-1970s. His great-grandson Barak Isidor Epstein relaunched the brand in Dallas in March 2025 with this preamplifier, which began shipping in late 2025 at about USD 3,390 to 3,590.
Key specs that matter
Its tube complement is two 12AX7 (ECC83) and two 12AU7 (ECC82). Inputs are Line 1, Line 2 and Phono, with MM or MC selected by a switch at the rear inputs. Line stage gain is 17.5 dB into a 50 kOhm load and 14 dB into 10 kOhm. On phono, the MM stage adds 26 dB for about 44 dB in total, and the MC stage adds a switchable 46 or 52 dB for about 64 or 70 dB. Input impedance is 50 kOhm nominal, 47 kOhm measured. RIAA accuracy is +1/-1.5 dB (20 Hz - 20 kHz). A rumble filter acts at 7 Hz with a 3 dB per octave slope. Mains voltage is 120 V or 240 V, specified at order. The unit measures 356 x 165 x 226 mm (W x H x D) and weighs 3.1 kg.
Engineering and use context
Damon Coffman, a tube physicist and engineer, designed the preamplifier on the basis of earlier Coffman Labs tube preamplifiers. RIAA equalisation is passive, and the circuit runs without negative feedback. Pilot specifies a straight-line signal path and leaves out bass and treble controls. Coupling capacitors are vintage oil-in-paper types. Construction combines point-to-point wiring, turret connections and a single-sided circuit board, and the dedicated power supply is shielded. All four tubes are hand-selected by PSVANE for Pilot Radio.
Pilot Radio designs and builds its products in Portland and Dallas. The casework, by the Dallas designer Shad Wilson, has a black hammer-tone finish and a gold tube cage in the style of the original Pilot units.
Pairing
The matching power amplifier is the Pilot 232 Stereophonic. A power amplifier with an input impedance of 10 kOhm or higher is required. Moving-magnet and moving-coil cartridges connect directly to the phono input.
Alternatives
Pilot Radio makes no other preamplifier, and its only other component, the 232 Stereophonic, is a power amplifier.