The Illusion is a stereo line preamplifier from Krell, introduced in 2014, with its power supply in a second chassis. Krell describes it as the bigger brother of the single-chassis Illusion II. Its intended partners are the Krell Solo 375 and Solo 575 mono power amplifiers, and it supports Krell's CAST current-mode interconnect.
Key specs that matter
Inputs are two CAST pairs, two XLR pairs, three RCA pairs and one RCA tape input. Main outputs are two CAST pairs, one XLR pair and one RCA pair, plus XLR and RCA subwoofer outputs for the optional crossover board and a buffered tape output. Frequency response is 20 Hz - 20 kHz (±0.02 dB) and 0.35 Hz - 720 kHz (-3 dB). THD+N is below 0.003% from 20 Hz to 20 kHz at 4 V RMS. Gain is 12 dB on CAST and balanced inputs and 6 dB on single-ended inputs. Input impedance is 40 kohms balanced and 20 kohms single-ended, and output impedance is 250 ohms balanced and 125 ohms single-ended. Maximum output is 16 V RMS balanced, and signal-to-noise ratio is above 109 dB (A-weighted). Dimensions are 438 x 97 x 464 mm and 8.1 kg for the preamplifier, and 438 x 97 x 448 mm and 12.7 kg for the power supply.
Engineering and use context
Krell built the Illusion as a dual mono design, with each channel on its own full-size board with separate regulation. It is a zero-feedback, balanced Krell Current Mode circuit with an open-loop bandwidth of 1.5 MHz. Surface-mount current mirrors with multiple outputs give high open-loop linearity. Volume control is a balanced current-mode 16-bit discrete R-2R ladder.
Between Krell components linked with CAST cables the signal is transferred as current, and the chain then has only one voltage gain stage. Modelled on the supplies of the Evolution e amplifiers, the separate power supply has a 290 VA transformer and 41,600 µF of capacitance. It also provides ±20 V DC for the Krell KPE phono stage.
An optional crossover board offers crossover points at 40, 55, 75 or 100 Hz, with Butterworth slopes of 12, 24 or 48 dB per octave or a 24 dB Linkwitz-Riley slope. Control connections are RS-232, an IR input, a 12 V trigger input, two programmable trigger outputs and an RJ-45 port.
Pairing
The matching power amplifiers are the Krell Solo 375 and Solo 575 monoblocks or other CAST-equipped Krell amplifiers. A Krell KPE phono stage takes its power from the Illusion supply. The subwoofer outputs require the optional crossover board.
Alternatives
The Krell Illusion II is the single-chassis version, with an ESS Sabre DAC, five digital inputs and a headphone output.